BCM4339XKWBGT Datasheet, PDF (110/183 Pages) Cypress Semiconductor – Single-Chip 5G WiFi IEEE 802.11ac MAC/Baseband/Radio with Integrated Bluetooth 4.1 and FM Receiver

BCM4339 Preliminary Data Sheet
Signal Descriptions
Table 20: FCFBGA, WLBGA, and WLCSP Signal Descriptions (Cont.)
WLBGA
Ball#
H6
FCFBGA
Ball#
U1
WLCSP
Bump#
45
Signal Name
BT_I2S_WS
Bluetooth Test Mode
–
U1
55
Bluetooth GPIO
–
–
59
–
–
60
–
C19
61
–
–
62
M6
–
91
Miscellaneous
B3
D5
3
BT_TM1
BT_GPIO_2
BT_GPIO_3
BT_GPIO_4
BT_GPIO_5
BT_AGPIO
WL_REG_ON
D3
C5
32
BT_REG_ON
K3
M3
57
BT_DEV_WAKE
J2
V3
58
BT_HOST_WAKE
B8
–
179
HSIC_STROBE/STROBE
B7
–
180
HSIC_DATA/DATA
B9
–
181
RREFHSIC
Integrated Voltage Regulators
C2
C3
15
C1
B1, B2, C1 11, 12, 14
SR_VDDBATA5V
SR_VDDBATP5V
Type Description
I/O _I²_{S WS; can be master (output)}
or slave (input).
I/O ARM JTAG mode.
I/O Bluetooth general-purpose I/O.
I/O Bluetooth general-purpose I/O.
I/O Bluetooth general-purpose I/O.
I/O Bluetooth general-purpose I/O.
I/O BT analog GPIO pin.
I Used by PMU to power up or
power down the internal
BCM4339 regulators used by
the WLAN section. Also, when
deasserted, this pin holds the
WLAN section in reset. This pin
has an internal 200 kΩ pull-
down resistor that is enabled by
default. It can be disabled
through programming.
I Used by PMU to power up or
power down the internal
BCM4339 regulators used by
the Bluetooth/FM section. Also,
when deasserted, this pin holds
the Bluetooth/FM section in
reset. This pin has an internal
200 kΩ pull-down resistor that
is enabled by default. It can be
disabled through programming.
I/O Bluetooth DEV_WAKE.
I/O Bluetooth HOST_WAKE.
I/O Unsupported. This pin can be
connected to ground or left
unconnected (no-connect).
I/O Unsupported. This pin can be
connected to ground or left
unconnected (no-connect).
I Unsupported. Leave this pin
unconnected (no-connect).
I Quiet VBAT.
I Power VBAT.
Broadcom^®
November 17, 2014 • 4339-DS106-R
Page 109