W83627THF_06 Datasheet, PDF (98/142 Pages) Winbond – Winbond LPC I/O

W83627THF/W83627THG
CRF3 (GP5[5:0] I/O selection register. Default 0xFF)
When set to a '1', respective GPIO port is programmed as an input port.
When set to a '0', respective GPIO port is programmed as an output port.
CRF4 (GP5[5:0] data register. Default 0x00)
If a port is programmed to be an output port, then its respective bit can be read/written.
If a port is programmed to be an input port, then its respective bit can only be read.
CRF5 (GP5[5:0] inversion register. Default 0x00)
When set to a '1', the incoming/outgoing port value is inverted.
When set to a '0', the incoming/outgoing port value is the same as in data register.
7.1.7 Logical Device 8 (GPIO Port 2 This power of the Port is VCC source)
CR30 (GP2[7:0] Default 0x00)
Bit 7 - 1 : Reserved.
Bit 0 = 1 Activate GPIO2.
= 0 GPIO2 is inactive.
CRF0 (GP2[7:0] I/O selection register. Default 0xFF)
When set to a '1', respective GPIO port is programmed as an input port.
When set to a '0', respective GPIO port is programmed as an output port.
CRF1 (GP2[7:0] data register. Default 0x00)
If a port is programmed to be an output port, then its respective bit can be read/written.
If a port is programmed to be an input port, then its respective bit can only be read.
CRF2 (GP2[7:0] inversion register. Default 0x00)
When set to a '1', the incoming/outgoing port value is inverted.
When set to a '0', the incoming/outgoing port value is the same as in data register.
CRF3 (Default 0x00)
Bit 7 - 4 : These bits select IRQ resource for IRQIN1.
Bit 3 - 0 : These bits select IRQ resource for IRQIN0.
- 91 -
Publication Release Date: September 26, 2006
Revision 1.2