W25Q256FVBIF-TR Datasheet, PDF (44/108 Pages) Winbond – 3V 256M-BIT SERIAL FLASH MEMORY WITH DUAL/QUAD SPI & QPI

W25Q256FV
8.2.13 Fast Read with 4-Byte Address (0Ch)
The Fast Read with 4-Byte Address instruction is similar to the Fast Read instruction except that it
requires 32-bit address instead of 24-bit address. No matter the device is operating in 3-Byte Address
Mode or 4-byte Address Mode, the Read Data with 4-Byte Address instruction will always require 32-bit
address to access the entire 256Mb memory.
The Fast Read with 4-Byte Address (0Ch) instruction is only supported in Standard SPI mode. In QPI
mode, the instruction code 0Ch is used for the “Burst Read with Wrap” instruction.
/CS
CLK
DI
(IO0)
DO
(IO1)
/CS
CLK
DI
(IO0)
DO
(IO1)
Mode 3
Mode 0
0 1 2 3 4 5 6 7 8 9 10
36 37 38 39
Instruction (0Ch)
32-Bit Address
31 30 29
*
High Impedance
3210
* ^{= MSB}
39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63
Dummy Clocks
0
High Impedance
Data Out 1
Data Out 2
76543210765432107
*
*
Figure 17. Fast Read with 4-Byte Address Instruction (SPI Mode only)
- 43 -