TH58NVG1S3AFT Datasheet, PDF (25/32 Pages) Toshiba Semiconductor – TOSHIBA MOS DIGITAL INTEGRATED CIRCUIT SILICON GATE CMOS

TH58NVG1S3AFT05
(5) Acceptable commands after Serial Input command "80H"
Once the Serial Input command "80H" has been input, do not input any command other than the Column
Address Change in Auto Program command "10H” or the Reset command "FFH".
80
FF
WE
RY / BY
Address input
If a command other than "10H" or "FFH" is input, the Program operation is not performed and the device
operation is set to the mode which the input command specifies..
80
XX
Mode specified by the command.
Command other than
"10H" or “FFH”
10
Programming cannot be executed.
(6) Addressing for program operation
Within a block, the pages must be programmed consecutively from the LSB (least significant bit) page of
the block to MSB (most significant bit) page of the block. Random page address programming is prohibited.
From the LSB page to MSB page
DATA IN: Data (1)
Data (64)
Data register
Ex.) Random page program (Prohibition)
DATA IN: Data (1)
Data (64)
Data register
Page 0
(1)
Page 1
(2)
Page 2
(3)
Page 0
(2)
Page 1
(32)
Page 2
(3)
Page 31
(32)
Page 31
(1)
Page 63
(64)
Page 63
(64)
Figure 17. page programming within a block
2003-05-19A 25/32