LM3S2B93 Datasheet, PDF (818/1194 Pages) Texas Instruments – Stellaris® LM3S2B93 Microcontroller

Inter-Integrated Circuit (I²C) Interface
Figure 16-13. Slave Command Sequence
Idle
Write OWN Slave
Address to
I2CSOAR
Write -------1
to I2CSCSR
Read I2CSCSR
NO _{TREQ bit=1?}
YES
Write data to
I2CSDR
NO _{RREQ bit=1?}
FBR is
also valid ^YES
Read data from
I2CSDR
16.4
Initialization and Configuration
The following example shows how to configure the I²C module to transmit a single byte as a master.
This assumes the system clock is 20 MHz.
1. Enable the I²C clock by writing a value of 0x0000.1000 to the RCGC1 register in the System
Control module (see page 270).
2. Enable the clock to the appropriate GPIO module via the RCGC2 register in the System Control
module (see page 282). To find out which GPIO port to enable, refer to Table 23-5 on page 1078.
3. In the GPIO module, enable the appropriate pins for their alternate function using the
GPIOAFSEL register (see page 441). To determine which GPIOs to configure, see Table
23-4 on page 1070.
4. Enable the I²C pins for open-drain operation. See page 446.
5. Configure the PMCn fields in the GPIOPCTL register to assign the I²C signals to the appropriate
pins. See page 459 and Table 23-5 on page 1078.
6. Initialize the I²C Master by writing the I2CMCR register with a value of 0x0000.0010.
818
January 20, 2012
Texas Instruments-Production Data