|
LM3S6422 Datasheet, PDF (25/609 Pages) Texas Instruments – Stellaris® LM3S6422 Microcontroller | |||
|
◁ |
Stellaris® LM3S6422 Microcontroller
Table 1. Revision History (continued)
Date
April 2008
Revision
2881
Description
â The ÎJA value was changed from 55.3 to 34 in the "Thermal Characteristics" table in the Operating
Characteristics chapter.
â Bit 31 of the DC3 register was incorrectly described in prior versions of the data sheet. A reset of
1 indicates that an even CCP pin is present and can be used as a 32-KHz input clock.
â Values for IDD_HIBERNATE were added to the "Detailed Power Specifications" table in the "Electrical
Characteristics" chapter.
â The "Hibernation Module DC Electricals" table was added to the "Electrical Characteristics" chapter.
â The maximum value on Core supply voltage (VDD25) in the "Maximum Ratings" table in the "Electrical
Characteristics" chapter was changed from 4 to 3.
â The operational frequency of the internal 30-kHz oscillator clock source is 30 kHz ± 50% (prior data
sheets incorrectly noted it as 30 kHz ± 30%).
â A value of 0x3 in bits 5:4 of the MISC register (OSCSRC) indicates the 30-KHz internal oscillator is
the input source for the oscillator. Prior data sheets incorrectly noted 0x3 as a reserved value.
â The reset for bits 6:4 of the RCC2 register (OSCSRC2) is 0x1 (IOSC). Prior data sheets incorrectly
noted the reset was 0x0 (MOSC).
â A note on high-current applications was added to the GPIO chapter:
For special high-current applications, the GPIO output buffers may be used with the following
restrictions. With the GPIO pins configured as 8-mA output drivers, a total of four GPIO outputs may
be used to sink current loads up to 18 mA each. At 18-mA sink current loading, the VOL value is
specified as 1.2 V. The high-current GPIO package pins must be selected such that there are only
a maximum of two per side of the physical package or BGA pin group with the total number of
high-current GPIO outputs not exceeding four for the entire package.
â A note on Schmitt inputs was added to the GPIO chapter:
Pins configured as digital inputs are Schmitt-triggered.
â The Buffer type on the WAKE pin changed from OD to - in the Signal Tables.
â The "Differential Sampling Range" figures in the ADC chapter were clarified.
â The last revision of the data sheet (revision 2550) introduced two errors that have now been corrected:
â The LQFP pin diagrams and pin tables were missing the comparator positive and negative input
pins.
â The base address was listed incorrectly in the FMPRE0 and FMPPE0 register bit diagrams.
â Additional minor data sheet clarifications and corrections.
March 2008
2550 Started tracking revision history.
June 18, 2012
25
Texas Instruments-Production Data
|
▷ |