TCM4400E Datasheet, PDF (7/64 Pages) Texas Instruments – GSM/DCS BASEBAND AND VOICE A/D AND D/A RF INTERFACE CIRCUIT

TCM4400E
GSM/DCS BASEBAND AND VOICE A/D
AND D/A RF INTERFACE CIRCUIT
SLWS082A – JULY 1999 – REVISED MARCH 2000
absolute maximum ratings over operating free-air temperature range (unless otherwise noted)^†
Supply voltage range, AV_DD, DV_DD (see Note 1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . – 0.3 to 6 V
Maximum voltage on any input, V_I max . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . V_DD +0.3 V / V_SS – 0.3 V
Storage temperature, T_stg . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . – 65°C to 150°C
Maximum junction temperature, T_J . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 150°C
† _{Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only, and}
functional operation of the device at these or any other conditions beyond those indicated under “recommended operating conditions” is not
implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
NOTE 1: Voltage measurements with respect to GND.
recommended operating conditions
Supply voltage range (AVDD, DVDD)
Operating temperature range
Digital I/O voltage with respect to DVSS
Analog I/O voltage with respect to AVSS
Difference between any AVDD or DVDD
MIN
2.7
–25
– 0.3
– 0.3
NOM
3.0
MAX
3.3
85
DVDD + 0.3
AVDD + 0.3
0.3
UNIT
Vdc
°C
Vdc
V
V
electrical characteristics over recommended operating free-air temperature range (unless
otherwise noted)
digital inputs and outputs
PARAMETER
Low-level output current with digital pad lower than 0.1 V (CMOS)
Low-level output current with digital pad lower than 0.4 V (TTL)
High-level output current with digital pad higher than VDD–0.1 V (CMOS)
High-level output current with digital pad higher than VDD–0.4 V (TTL)
Minimum high-level input voltage, VIH
Maximum low level input voltage, VIL
Output current on high impedance state outputs
Input current (any input) when input high
Input current (standard inputs) when input low
Input current (inputs with pullup TMS, TDI ,TEST1 ,TEST2) when input low
MIN
0
0
–40
–1
Vdd–0.3
–15
–1
TYP MAX
40
1
0
0
Vss+0.3
15
1
15
UNIT
µA
mA
µA
mA
V
V
µA
µA
µA
µA
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265
7