N25Q128A13ESE40G Datasheet, PDF (42/81 Pages) Micron Technology – Micron Serial NOR Flash Memory 3V, Multiple I/O, 4KB Sector Erase N25Q128A

128Mb, 3V, Multiple I/O Serial Flash Memory
PROGRAM Operations
PROGRAM Operations
PROGRAM commands are initiated by first executing the WRITE ENABLE command to
set the write enable latch bit to 1. S# is then driven LOW and held LOW until the eighth
bit of the last data byte has been latched in, after which it must be driven HIGH. The
command code is input on DQ0, followed by input on DQ[n] of address bytes and at
least one data byte. Each address bit is latched in during the rising edge of the clock.
When S# is driven HIGH, the operation, which is self-timed, is initiated; its duration is
t_PP.
If the bits of the least significant address, which is the starting address, are not all zero,
all data transmitted beyond the end of the current page is programmed from the start-
ing address of the same page. If the number of bytes sent to the device exceed the maxi-
mum page size, previously latched data is discarded and only the last maximum page-
size number of data bytes are guaranteed to be programmed correctly within the same
page. If the number of bytes sent to the device is less than the maximum page size, they
are correctly programmed at the specified addresses without any effect on the other
bytes of the same page.
When the operation is in progress, the write in progress bit is set to 1. The write enable
latch bit is cleared to 0, whether the operation is successful or not. The status register
and flag status register can be polled for the operation status. An operation can be
paused or resumed by the PROGRAM/ERASE SUSPEND or PROGRAM/ERASE RESUME
command, respectively. When the operation completes, the write in progress bit is
cleared to 0.
If the operation times out, the write enable latch bit is reset and the program fail bit is
set to 1. If S# is not driven HIGH, the command is not executed, flag status register error
bits are not set, and the write enable latch remains set to 1. When a command is applied
to a protected sector, the command is not executed, the write enable latch bit remains
set to 1, and flag status register bits 1 and 4 are set.
Table 24: Data/Address Lines for PROGRAM Commands
Note 1 applies to entire table
Command Name
PAGE PROGRAM
DUAL INPUT FAST PROGRAM
EXTENDED DUAL INPUT
FAST PROGRAM
QUAD INPUT FAST PROGRAM
EXTENDED QUAD INPUT
FAST PROGRAM
Data In
DQ0
DQ[1:0]
DQ[1:0]
DQ[3:0]
DQ[3:0]
Address In
DQ0
DQ0
DQ[1:0]
DQ0
DQ[3:0]
Extended
Yes
Yes
Yes
Yes
Yes
Dual
Yes
Yes
Yes
No
No
Quad
Yes
No
No
Yes
Yes
Note: 1. Yes in the protocol columns indicates that the command is supported and has the same
functionality and command sequence as other commands marked Yes.
PDF: 09005aef845665fe
n25q_128mb_3v_65nm.pdf - Rev. P 06/13 EN
42
Micron Technology, Inc. reserves the right to change products or specifications without notice.
© 2012 Micron Technology, Inc. All rights reserved.