English
Language : 

PIC24FJ256GB110-I Datasheet, PDF (251/328 Pages) Microchip Technology – 64/80/100-Pin, 16-Bit Flash Microcontrollers with USB On-The-Go (OTG)
PIC24FJ256GB110 FAMILY
21.0 10-BIT HIGH-SPEED A/D
CONVERTER
Note:
This data sheet summarizes the features
of this group of PIC24F devices. It is not
intended to be a comprehensive reference
source. For more information, refer to the
“PIC24F Family Reference Manual”,
”Section 17. 10-Bit A/D Converter”
(DS39705).
The 10-bit A/D Converter has the following key
features:
• Successive Approximation (SAR) conversion
• Conversion speeds of up to 500 ksps
• 16 analog input pins
• External voltage reference input pins
• Internal band gap reference inputs
• Automatic Channel Scan mode
• Selectable conversion trigger source
• 16-word conversion result buffer
• Selectable Buffer Fill modes
• Four result alignment options
• Operation during CPU Sleep and Idle modes
On all PIC24FJ256GB110 family devices, the 10-bit
A/D Converter has 16 analog input pins, designated
AN0 through AN15. In addition, there are two analog
input pins for external voltage reference connections
(VREF+ and VREF-). These voltage reference inputs
may be shared with other analog input pins.
A block diagram of the A/D Converter is shown in
Figure 21-1.
To perform an A/D conversion:
1. Configure the A/D module:
a) Configure port pins as analog inputs and/or
select band gap reference inputs
(AD1PCFGL<15:0> and AD1PCFGH<1:0>).
b) Select voltage reference source to match
expected range on analog inputs
(AD1CON2<15:13>).
c) Select the analog conversion clock to
match desired data rate with processor
clock (AD1CON3<7:0>).
d) Select the appropriate sample/conversion
sequence (AD1CON1<7:5> and
AD1CON3<12:8>).
e) Select how conversion results are
presented in the buffer (AD1CON1<9:8>).
f) Select interrupt rate (AD1CON2<5:2>).
g) Turn on A/D module (AD1CON1<15>).
2. Configure A/D interrupt (if required):
a) Clear the AD1IF bit.
b) Select A/D interrupt priority.
© 2008 Microchip Technology Inc.
Preliminary
DS39897B-page 249