PIC18F2525_08 Datasheet, PDF (230/412 Pages) Microchip Technology – 28/40/44-Pin Enhanced Flash Microcontrollers with 10-Bit A/D and nanoWatt Technology

PIC18F2525/2620/4525/4620
19.1 A/D Acquisition Requirements
For the A/D converter to meet its specified accuracy,
the charge holding capacitor (CHOLD) must be allowed
to fully charge to the input channel voltage level. The
analog input model is shown in Figure 19-3. The
source impedance (RS) and the internal sampling
switch (RSS) impedance directly affect the time
required to charge the capacitor CHOLD. The sampling
switch (RSS) impedance varies over the device voltage
(VDD). The source impedance affects the offset voltage
at the analog input (due to pin leakage current). The
maximum recommended impedance for analog
sources is 2.5 kΩ. After the analog input channel is
selected (changed), the channel must be sampled for
at least the minimum acquisition time before starting a
conversion.
Note:
When the conversion is started, the
holding capacitor is disconnected from the
input pin.
To calculate the minimum acquisition time,
Equation 19-1 may be used. This equation assumes
that 1/2 LSb error is used (1024 steps for the A/D). The
1/2 LSb error is the maximum error allowed for the A/D
to meet its specified resolution.
Example 19-3 shows the calculation of the minimum
required acquisition time TACQ. This calculation is
based on the following application system
assumptions:
CHOLD
= 25 pF
Rs
= 2.5 kΩ
Conversion Error ≤ 1/2 LSb
VDD
= 5V → Rss = 2 kΩ
Temperature
= 85°C (system max.)
EQUATION 19-1: ACQUISITION TIME
TACQ = Amplifier Settling Time + Holding Capacitor Charging Time + Temperature Coefficient
= TAMP + TC + TCOFF
EQUATION 19-2: A/D MINIMUM CHARGING TIME
VHOLD =
or
TC
=
(VREF – (VREF/2048)) • (1 – e^{(-TC/CHOLD(RIC + RSS + RS))})
-(CHOLD)(RIC + RSS + RS) ln(1/2048)
EQUATION 19-3: CALCULATING THE MINIMUM REQUIRED ACQUISITION TIME
TACQ = TAMP + TC + TCOFF
TAMP = 0.2 μs
TCOFF =
(Temp – 25°C)(0.02 μs/°C)
(85°C – 25°C)(0.02 μs/°C)
1.2 μs
Temperature coefficient is only required for temperatures > 25°C. Below 25°C, TCOFF = 0 ms.
TC
= -(CHOLD)(RIC + RSS + RS) ln(1/2047)
-(25 pF) (1 kΩ + 2 kΩ + 2.5 kΩ) ln(0.0004883)
1.05 μs
TACQ = 0.2 μs + 1 μs + 1.2 μs
2.4 μs
DS39626E-page 228
© 2008 Microchip Technology Inc.