|
PIC24HJ12GP201 Datasheet, PDF (173/234 Pages) Microchip Technology – High-Performance, 16-Bit Microcontrollers | |||
|
◁ |
PIC24HJ12GP201/202
19.0 INSTRUCTION SET SUMMARY
Note:
This data sheet summarizes the features
of this group of PIC24HJ12GP201/202
devices. It is not intended to be a
comprehensive reference source. To
complement the information in this data
sheet, refer to the âPIC24H Family
Reference Manualâ. Please see the
Microchip web site (www.microchip.com)
for the latest PIC24H Family Reference
Manual chapters.
The PIC24H instruction set is identical to that of the
PIC24F, and is a subset of the dsPIC30F/33F
instruction set.
Most instructions are a single program memory word
(24 bits). Only three instructions require two program
memory locations.
Each single-word instruction is a 24-bit word, divided
into an 8-bit opcode, which specifies the instruction
type and one or more operands, which further specify
the operation of the instruction.
The instruction set is highly orthogonal and is grouped
into five basic categories:
⢠Word or byte-oriented operations
⢠Bit-oriented operations
⢠Literal operations
⢠DSP operations
⢠Control operations
Table 19-1 shows the general symbols used in
describing the instructions.
The PIC24H instruction set summary in Table 19-2 lists
all the instructions, along with the status flags affected
by each instruction.
Most word or byte-oriented W register instructions
(including barrel shift instructions) have three
operands:
⢠The first source operand which is typically a
register âWbâ without any address modifier
⢠The second source operand which is typically a
register âWsâ with or without an address modifier
⢠The destination of the result which is typically a
register âWdâ with or without an address modifier
However, word or byte-oriented file register instruc-
tions have two operands:
⢠The file register specified by the value âfâ
⢠The destination, which could either be the file
register âfâ or the W0 register, which is denoted as
âWREGâ
Most bit-oriented instructions (including simple
rotate/shift instructions) have two operands:
⢠The W register (with or without an address
modifier) or file register (specified by the value of
âWsâ or âfâ)
⢠The bit in the W register or file register
(specified by a literal value or indirectly by the
contents of register âWbâ)
The literal instructions that involve data movement may
use some of the following operands:
⢠A literal value to be loaded into a W register or file
register (specified by the value of âkâ)
⢠The W register or file register where the literal
value is to be loaded (specified by âWbâ or âfâ)
However, literal instructions that involve arithmetic or
logical operations use some of the following operands:
⢠The first source operand which is a register âWbâ
without any address modifier
⢠The second source operand which is a literal
value
⢠The destination of the result (only if not the same
as the first source operand) which is typically a
register âWdâ with or without an address modifier
The control instructions may use some of the following
operands:
⢠A program memory address
⢠The mode of the table read and table write
instructions
© 2007 Microchip Technology Inc.
Preliminary
DS70282B-page 171
|
▷ |