PIC32MX320F032H_11 Datasheet, PDF (171/214 Pages) Microchip Technology – High-Performance, General Purpose and USB, 32-bit Flash Microcontrollers

PIC32MX3XX/4XX
FIGURE 29-10:
SCKx
(CKP = 0)
SCKx
(CKP = 1)
SPIx MODULE MASTER MODE (CKE = 0) TIMING CHARACTERISTICS
SP11
SP10
SP21
SP20
SP35
SP20
SP21
SDOx
MSb
SDIx
SP31
MSb In
SP40 SP41
Note: Refer to Figure 29-1 for load conditions.
Bit 14 - - - - - -1
LSb
Bit 14 - - - -1
SP30
LSb In
TABLE 29-28: SPIx MASTER MODE (CKE = 0) TIMING REQUIREMENTS
AC CHARACTERISTICS
Standard Operating Conditions: 2.3V to 3.6V
(unless otherwise stated)
Operating temperature -40°C ≤TA ≤+85°C for Industrial
-40°C ≤TA ≤+105°C for V-Temp
Param.
No.
Symbol
SP10
SP11
SP20
SP21
SP30
SP31
TSCL
TSCH
TSCF
TSCR
TDOF
TDOR
Characteristics⁽¹⁾
Min. Typical⁽²⁾ Max. Units
SCKx Output Low Time⁽³⁾
TSCK/2
—
SCKx Output High Time⁽³⁾
TSCK/2
—
SCKx Output Fall Time⁽⁴⁾
—
—
SCKx Output Rise Time⁽⁴⁾
—
—
SDOx Data Output Fall Time⁽⁴⁾
—
—
SDOx Data Output Rise Time⁽⁴⁾ —
—
— ns
— ns
— ns
— ^ns
— ^ns
— ^ns
Conditions
—
—
See parameter DO32
See parameter DO31
See parameter DO32
See parameter DO31
SP35 TSCH2DOV, SDOx Data Output Valid after
—
TSCL2DOV SCKx Edge
—
—
15 ^ns
—
20 ^ns
VDD > 2.7V
VDD < 2.7V
SP40 TDIV2SCH, Setup Time of SDIx Data Input
10
—
— ns
—
TDIV2SCL to SCKx Edge
SP41 TSCH2DIL, Hold Time of SDIx Data Input
10
—
— ns
—
TSCL2DIL to SCKx Edge
Note 1:
2:
3:
4:
These parameters are characterized, but not tested in manufacturing.
Data in “Typical” column is at 3.3V, 25°C unless otherwise stated. Parameters are for design guidance only
and are not tested.
The minimum clock period for SCKx is 40 ns. Therefore, the clock generated in Master mode must not
violate this specification.
Assumes 50 pF load on all SPIx pins.
© 2011 Microchip Technology Inc.
DS61143H-page 171