PIC24F16KL402 Datasheet, PDF (159/260 Pages) Microchip Technology – Low-Power, Low-Cost, General Purpose 16-Bit Flash Microcontrollers with nanoWatt XLP Technology

PIC24F16KL402 FAMILY
REGISTER 19-1: AD1CON1: A/D CONTROL REGISTER 1
R/W-0
U-0
R/W-0
U-0
U-0
ADON⁽¹⁾
—
ADSIDL
—
—
bit 15
U-0
R/W-0
R/W-0
—
FORM1
FORM0
bit 8
R/W-0
R/W-0
R/W-0
U-0
SSRC2
SSRC1
SSRC0
—
bit 7
U-0
R/W-0 R/W-0, HSC R-0, HSC
—
ASAM
SAMP
DONE
bit 0
Legend:
R = Readable bit
-n = Value at POR
HSC = Hardware Settable/Clearable bit
W = Writable bit
U = Unimplemented bit, read as ‘0’
‘1’ = Bit is set
‘0’ = Bit is cleared
x = Bit is unknown
bit 15
bit 14
bit 13
bit 12-10
bit 9-8
bit 7-5
bit 4-3
bit 2
bit 1
bit 0
ADON: A/D Operating Mode bit⁽¹⁾
1 = A/D Converter module is operating
0 = A/D Converter is off
Unimplemented: Read as ‘0’
ADSIDL: Stop in Idle Mode bit
1 = Discontinue module operation when device enters Idle mode
0 = Continue module operation in Idle mode
Unimplemented: Read as ‘0’
FORM<1:0>: Data Output Format bits
11 = Signed fractional (sddd dddd dd00 0000)
10 = Fractional (dddd dddd dd00 0000)
01 = Signed integer (ssss sssd dddd dddd)
00 = Integer (0000 00dd dddd dddd)
SSRC<2:0>: Conversion Trigger Source Select bits
111 = Internal counter ends sampling and starts conversion (auto-convert)
110 = Reserved
101 = Reserved
100 = Reserved
011 = Reserved
010 = Timer1 compare ends sampling and starts conversion
001 = Active transition on INT0 pin ends sampling and starts conversion
000 = Clearing the SAMP bit ends sampling and starts conversion
Unimplemented: Read as ‘0’
ASAM: A/D Sample Auto-Start bit
1 = Sampling begins immediately after the last conversion completes; SAMP bit is auto-set
0 = Sampling begins when the SAMP bit is set
SAMP: A/D Sample Enable bit
1 = A/D sample/hold amplifier is sampling input
0 = A/D sample/hold amplifier is holding
DONE: A/D Conversion Status bit
1 = A/D conversion is done
0 = A/D conversion is not done
Note 1: Values of ADC1BUFx registers will not retain their values once the ADON bit is cleared. Read out the
conversion values from the buffer before disabling the module.
 2011 Microchip Technology Inc.
DS31037B-page 159