71M6541D Datasheet, PDF (60/166 Pages) Maxim Integrated Products – 0.1% Accuracy Over 2000:1 Current Range Energy Meter ICs

71M6541D/F/G and 71M6542F/G Data Sheet
Value in DIO_Rn[2:0] Resource Selected for SEGDIOn or PB Pin
5
Low priority I/O interrupt (INT1)
Note:
Resources are selectable only on SEGDIO2 through SEGDIO11 and the
PB pin. See Table 48 (71M6541D/F/G) and Table 52 (71M6542F/G).
When driving LEDs, relay coils etc., the DIO pins should sink the current into GNDD (as
shown in Figure 20, right), not source it from V3P3D (as shown in Figure 20, left). This is due
to the resistance of the internal switch that connects V3P3D to either V3P3SYS or VBAT. See
6.4.6 V3P3D Switch on page 143.
Sourcing current in or out of DIO pins other than those dedicated for wake functions, for
example with pull-up or pull-down resistors, must be avoided. Violating this rule leads to
increased quiescent current in sleep and LCD modes.
MISSION
LCD/SLEEP
BROWNOUT
V3P3SYS
VBAT
V3P3D
HIGH
HIGH-Z
LOW
DIO
MISSION
LCD/SLEEP
BROWNOUT
V3P3SYS
VBAT
V3P3D
HIGH
HIGH-Z
LOW
DIO
GNDD
GNDD
Not recommended
Recommended
Figure 20: Connecting an External Load to DIO Pins