ISL6329 Datasheet, PDF (16/38 Pages) Intersil Corporation – Dual PWM Controller Powering AMD SVI Split-Plane Processors

ISL6329
TABLE 1. PRE-PWROK METAL VID CODES
SVC
SVD
OUTPUT VOLTAGE
(V)
0
0
1.1
0
1
1.0
1
0
0.9
1
1
0.8
The Pre-PWROK metal VID code is decoded and latched on the
rising edge of the enable signal. Once enabled, the ISL6329
passes the Pre-PWROK metal VID code on to internal DAC
circuitry. The internal DAC circuitry begins to ramp both the VDD
and VDDNB planes to the decoded Pre-PWROK metal VID output
level. The digital soft-start circuitry actually stair steps the
internal reference to the target gradually over a fixed interval. The
controlled ramp of both output voltage planes reduces in-rush
current during the soft-start interval. At the end of the soft-start
interval, the VDDPWRGD output transitions high indicating both
output planes are within regulation limits.
SVI Mode
Once the controller has successfully soft-started and VDDPWRGD
transitions high, the Northbridge SVI interface can assert PWROK
to signal the ISL6329 to prepare for SVI commands. The
controller actively monitors the SVI interface for set VID
commands to move the plane voltages to start-up VID values.
Details of the SVI Bus protocol are provided in the AMD Design
Guide for Voltage Regulator Controllers Accepting Serial VID
Codes specification.
Once the set VID command is received, the ISL6329 decodes the
information to determine which plane and the VID target
required. See Table 2. The internal DAC circuitry steps the
required output plane voltage to the new VID level. During this
time one or both of the planes could be targeted. In the event the
core voltage plane, VDD, is commanded to power off by serial VID
commands, the VDDPWRGD signal remains asserted. The
Northbridge voltage plane must remain active during this time.
If the PWROK input is de-asserted, then the controller steps both
VDD and VDDNB planes back to the stored Pre-PWROK metal VID
level in the holding register from initial soft-start. No attempt is
made to read the SVC and SVD inputs during this time. If PWROK
is reasserted, then the on-board SVI interface waits for a set VID
command.
VCC
1
2
3
456
7
8
9 10
11
12
SVC
SVD
ENABLE
PWROK
VDD and VDDNB
metal_VID ^V_SVI
metal_VID
V_SVI
VDDPWRGD
FIGURE 7. SVI INTERFACE TIMING DIAGRAM: TYPICAL PRE-PWROK METAL VID START-UP
16
FN7800.0
April 19, 2011