TC1798 Datasheet, PDF (198/200 Pages) Infineon Technologies AG – 32-Bit Single-Chip Microcontroller

TC1798
History
• add parameter t_{POR_APP}
• replace in Operating Conditions Parameter Note MA = modulation amplitude by
footnote 1)
• remove the redundant test condition I_OH for RDSON NMOS
• remove the redundant test condition I_OL for RDSON PMOS
• add parameter V_ILSD to class S pads
• remove footnote 2 from FADC
• remove capacitance conditions for LVDS pad parameters as loads are defined by
interface (MSC) timings
The following changes where done between Version 0.7 and 1.0 of this document:
• add product options SAK-TC1798S-512F300EP and SAK-TC1798N-512F300EP
• remove product options SAK-TC1798F-512F240EP and SAK-TC1798F-
512F240EL
• update block diagrams to cover new options
• add note to TC1798 Logic Symbol figure and pin list for E-RAY pins availability
• add identification registers for new options
• adapt Absolute Maximum Rating
• clarify pad supply levels in Pin Reliability in Overload section
• correct errors for analog inputs in tables 10 and 11
• add note at the end of Pin Reliability in Overload section
• clarify wording for valid operating conditions
• correct section Extended Range Operating Conditions for the 3.3 V area
• increase limit in Extended Range Operating Conditions from 1 hour to 1000 hours
• add negative limit for class S pad leakage
• removed RDSON parameters for class F pads weak driver as only medium is
available and update values
• change description of parameter t_CAL for the ADC
• update footnote 10 for the ADC
• update definition of INL and TUE for ADC3
• split FADC DNL parameter into two conditions and change value for gain 4 and 8
• update all current values of table 28 (Power Supply Parameters)
• add footnote 5 to I_DDP
• improve parameters I_DDFL3
• add footnote for D-Flash currents in power section
• add section 5.2.6.1.
• rework first sentence for chapter 5.3
• increase max values for parameter t_B
• reduce min value for t_L for both PLLs
• split f_VCO for the system PLL into two conditions
• change formula 10
• add for MLI and SSC timing parameter: valid strong driver medium edge only
• change MLI parameter t₁₇ min value
Data Sheet
4
V 1.1, 2014-05