TC1798 Datasheet, PDF (197/200 Pages) Infineon Technologies AG – 32-Bit Single-Chip Microcontroller

TC1798
History
• add min and max value for Q_CONV and adapt typ value
• add load conditions for t_FF1 and t_RF1
• add conditions to PLL parameter t_L
• change DAP parameter t₁₉ from SR to CC classification
• remove footnote 2 for the FADC
• adapt IDs for AB step
• move pin AN49 from W2 to W1
• move pin AN48 from W1 to W2
• removed footnote 2 in table 9
• change max value for ADC parameter t_S from 255 to 257
•
• change P1.7 input CC60INB to CC61INB
• remove O2 OUT105 for GPTA1 of P14.9
• add O2 T3OUt for GPT121 of P14.9
• changed the name for O3 from EVTO2 to EVTO1 for P0.5
• changed the name for O3 from EVTO3 to EVTO2 for P0.6
• changed the name for O3 from EVTO4 to EVTO3 for P0.7
• changed the name for O1 and O2 from OUT70 to OUT71 for P1.15
• add input function SLSI2 for SSC2 to P4.9
The following changes where done between Version 0.62 and 0.63 of this document:
• change P1.7 input CC60INB to CC61INB
• remove O2 OUT105 for GPTA1 of P14.9
• add O2 T3OUt for GPT121 of P14.9
• changed the name for O3 from EVTO2 to EVTO1 for P0.5
• changed the name for O3 from EVTO3 to EVTO2 for P0.6
• changed the name for O3 from EVTO4 to EVTO3 for P0.7
• changed the name for O1 and O2 from OUT70 to OUT71 for P1.15
• add input function SLSI2 for SSC2 to P4.9
• add input function CC60INC forCCU61 for P2.10
• change back for port 3.0 for symbol CC60INC from CCU61 to CCU62
• change input function T13HRE from CCU60 to CCU63
• change for port 6.15 the symbol from CC61(CCU60) to CC60(CCU61)
• change for port 8.2 the symbol from CC61(CCU60) to COUT63(CCU61)
• change for port 14.10 the symbol from T3OUT(GPT120) to T6OUT(GPT121)
• add to all SSC signal the assosiated SSC module where is was missing in the pinning
• add section Pin Reliability in Overload
• incease values for absolute maximium parameters I_IN and SumI_IN
• correct P14.8 O2 as this was incorrected label as O1
The following changes where done between Version 0.63 and 0.7 of this document:
• change value R_ΘJCT from 2.6 to 3.5 K/W
• change value R_ΘJCB from 4.3 to 6.1 K/W
• change value R_ΘJA from 13.6 to 14.7 K/W
Data Sheet
3
V 1.1, 2014-05