MC908AP16CFAE Datasheet, PDF (295/324 Pages) Freescale Semiconductor, Inc – Table of Contents

Break Module Registers
21.4.1 Wait Mode
If enabled, the break module is active in wait mode. In the break routine, the user can subtract one from
the return address on the stack if SBSW is set. (see Chapter 7 System Integration Module (SIM)) Clear
the BW bit by writing logic 0 to it.
21.4.2 Stop Mode
A break interrupt causes exit from stop mode and sets the SBSW bit in the break status register.
21.5 Break Module Registers
These registers control and monitor operation of the break module:
• Break status and control register (BRKSCR)
• Break address register high (BRKH)
• Break address register low (BRKL)
• SIM break status register (SBSR)
• SIM break flag control register (SBFCR)
21.5.1 Break Status and Control Register
The break status and control register (BRKSCR) contains break module enable and status bits.
Address: $FE0E
Bit 7
6
5
4
3
2
1
Bit 0
Read:
0
0
0
0
0
0
BRKE BRKA
Write:
Reset: 0
0
0
0
0
0
0
0
= Unimplemented
Figure 21-3. Break Status and Control Register (BRKSCR)
BRKE — Break Enable Bit
This read/write bit enables breaks on break address register matches. Clear BRKE by writing a logic
0 to bit 7. Reset clears the BRKE bit.
1 = Breaks enabled on 16-bit address match
0 = Breaks disabled on 16-bit address match
BRKA — Break Active Bit
This read/write status and control bit is set when a break address match occurs. Writing a logic 1 to
BRKA generates a break interrupt. Clear BRKA by writing a logic 0 to it before exiting the break routine.
Reset clears the BRKA bit.
1 = (When read) Break address match
0 = (When read) No break address match
MC68HC908AP Family Data Sheet, Rev. 4
Freescale Semiconductor
293