MC908AP16CFAE Datasheet, PDF (112/324 Pages) Freescale Semiconductor, Inc – Table of Contents

System Integration Module (SIM)
7.7.1 SIM Break Status Register
The SIM break status register (SBSR) contains a flag to indicate that a break caused an exit from stop
mode or wait mode.
Address: $FE00
Bit 7
6
5
4
3
2
1
Bit 0
Read:
SBSW
R
R
R
R
R
R
R
Write:
Note
Reset:
0
Note: Writing a logic 0 clears SBSW.
R
= Reserved
Figure 7-20. SIM Break Status Register (SBSR)
SBSW — Break Wait Bit
This status bit is set when a break interrupt causes an exit from wait mode or stop mode. Clear SBSW
by writing a logic 0 to it. Reset clears SBSW.
1 = Stop mode or wait mode was exited by break interrupt
0 = Stop mode or wait mode was not exited by break interrupt
SBSW can be read within the break interrupt routine. The user can modify the return address on the stack
by subtracting 1 from it. The following code is an example.
This code works if the H register has been pushed onto the stack in the break
service routine software. This code should be executed at the end of the break
service routine software.
HIBYTE EQU
5
LOBYTE EQU
6
If not SBSW, do RTI
BRCLR SBSW,SBSR, RETURN
;See if wait mode or stop mode was exited by
;break.
TST
LOBYTE,SP
;If RETURNLO is not zero,
BNE
DOLO
;then just decrement low byte.
DEC
HIBYTE,SP
;Else deal with high byte, too.
DOLO
DEC
LOBYTE,SP
;Point to WAIT/STOP opcode.
RETURN PULH
RTI
;Restore H register.
MC68HC908AP Family Data Sheet, Rev. 4
112
Freescale Semiconductor