MC908AP16CFAE Datasheet, PDF (106/324 Pages) Freescale Semiconductor, Inc – Table of Contents

System Integration Module (SIM)
CLI
LDA #$FF
INT1
PSHH
PULH
RTI
BACKGROUND
ROUTINE
INT1 INTERRUPT SERVICE ROUTINE
INT2
PSHH
INT2 INTERRUPT SERVICE ROUTINE
PULH
RTI
Figure 7-11. Interrupt Recognition Example
The LDA opcode is prefetched by both the INT1 and INT2 RTI instructions. However, in the case of the
INT1 RTI prefetch, this is a redundant operation.
NOTE
To maintain compatibility with the M6805 Family, the H register is not
pushed on the stack during interrupt entry. If the interrupt service routine
modifies the H register or uses the indexed addressing mode, software
should save the H register and then restore it prior to exiting the routine.
7.5.1.2 SWI Instruction
The SWI instruction is a non-maskable instruction that causes an interrupt regardless of the state of the
interrupt mask (I bit) in the condition code register.
NOTE
A software interrupt pushes PC onto the stack. A software interrupt does
not push PC – 1, as a hardware interrupt does.
7.5.2 Interrupt Status Registers
The flags in the interrupt status registers identify maskable interrupt sources. Table 7-3 summarizes the
interrupt sources and the interrupt status register flags that they set. The interrupt status registers can be
useful for debugging.
MC68HC908AP Family Data Sheet, Rev. 4
106
Freescale Semiconductor