MC9S08QG8_09 Datasheet, PDF (115/314 Pages) Freescale Semiconductor, Inc – HCS08 Microcontrollers

Analog Comparator (S08ACMPV2)
8.4 Functional Description
The analog comparator can be used to compare two analog input voltages applied to ACMP+ and ACMP–;
or it can be used to compare an analog input voltage applied to ACMP– with an internal bandgap reference
voltage. ACBGS is used to select between the bandgap reference voltage or the ACMP+ pin as the input
to the non-inverting input of the analog comparator. The comparator output is high when the non-inverting
input is greater than the inverting input, and is low when the non-inverting input is less than the inverting
input. ACMOD is used to select the condition which will cause ACF to be set. ACF can be set on a rising
edge of the comparator output, a falling edge of the comparator output, or either a rising or a falling edge
(toggle). The comparator output can be read directly through ACO. The comparator output can be driven
onto the ACMPO pin using ACOPE.
MC9S08QG8 and MC9S08QG4 Data Sheet, Rev. 5
Freescale Semiconductor
113