PD45128441-I Datasheet, PDF (31/89 Pages) Elpida Memory – 128M-bit Synchronous DRAM 4-bank, LVTTL WTR (Wide Temperature Range)

µPD45128441-I, 45128841-I, 45128163-I
12. Burst Termination
There are two methods to terminate a burst operation other than using a Read or a Write command. One is the
burst stop command and the other is the precharge command.
12.1 Burst Stop Command
During a read cycle, when the burst stop command is issued, the burst read data are terminated and the data bus
goes to Hi-Z after the /CAS latency from the burst stop command.
Burst length = X
T0
T1
T2
T3
T4
T5
T6
T7
CLK
Command
/CAS latency = 2
DQ
/CAS latency = 3
DQ
READ
BST
Q1
Q2
Q3
Q1
Q2
Q3
Hi-Z
Hi-Z
Remark BST: Burst stop command
During a write cycle, when the burst stop command is issued, the burst write data are terminated and data bus goes
to Hi-Z at the same clock with the burst stop command.
Burst length = X
T0
T1
T2
T3
T4
T5
T6
T7
CLK
Command
WRITE
BST
/CAS latency = 2, 3
Hi-Z
DQ
D1
D2
D3
D4
Remark BST: Burst stop command
Preliminary Data Sheet E0233N10
31