S6E1C3 Datasheet, PDF (48/107 Pages) Cypress Semiconductor – 32-bit ARM® Cortex®-M0+ FM0+ Microcontroller

S6E1C3 Series
11.2 Recommended Operating Conditions
Parameter
Power supply voltage
Symbol
VCC
Conditions
-
Value
Min
Max
1.65 *³
3.6
3.0
3.6
Unit
V
V
(VSS= 0.0 V)
Remarks
*1
Analog reference voltage
AVRH
-
2.7
VCC
AVRL
-
VSS
Smoothing capacitor
CS
-
1
Operating temperature
Ta
-
- 40
*1: When P81/UDP0 and P80/UDM0 pins are used as USB (UDP0, UDM0).
VCC
VCC
VSS
10
+ 105
V
VCC ≥ 2.7 V
V
VCC < 2.7 V
V
μF
For regulator*²
°C
*2: See "C Pin" in "7. Handling Devices" for the connection of the smoothing capacitor.
*3: In between less than the minimum power supply voltage reset / interrupt detection voltage or more, instruction execution and low
voltage detection function by built-in High-speed CR (including Main PLL is used) or built-in Low-speed CR is possible to operate
only.
<WARNING>
1. The recommended operating conditions are required in order to ensure the normal operation of the semiconductor device. All of
the device's electrical characteristics are warranted when the device is operated within these ranges.
2. Always use semiconductor devices within their recommended operating condition ranges. Operation outside these ranges may
adversely affect reliability and could result in device failure.
3. No warranty is made with respect to uses, operating conditions, or combinations not represented on the data sheet.
4. Users considering application outside the listed conditions are advised to contact their representatives beforehand.
Document Number: 002-00233 Rev.*B
Page 48 of 107