EPM240 Datasheet, PDF (83/86 Pages) Altera Corporation – JTAG & In-System Programmability

Chapter 5: DC and Switching Characteristics
Document Revision History
Document Revision History
Table 5–32 shows the revision history for this chapter.
Table 5–32. Document Revision History (Part 1 of 2)
Date and Revision
November 2008,
version 2.4
October 2008,
version 2.3
July 2008,
version 2.2
March 2008,
version 2.1
December 2007,
version 2.0
December 2006,
version 1.8
July 2006,
version 1.7
February 2006,
version 1.6
November 2005,
version 1.5
August 2005,
version 1.4
June 2005,
version 1.3
Changes Made
■ Updated Table 5–2.
■ Updated “Internal Timing Parameters” section.
■ Updated New Document Format.
■ Updated Figure 5–1.
■ Updated Table 5–14 , Table 5–23 , and Table 5–24.
■ Added (Note 5) to Table 5–4.
■ Updated (Note 3) and (4) to Table 5–1.
■ Updated Table 5–2 and added (Note 5).
■ Updated ICCSTANDBY and ICCPOWERUP information and added
IPULLUP information in Table 5–4.
■ Added (Note 1) to Table 5–10.
■ Updated Figure 5–2.
■ Added (Note 1) to Table 5–13.
■ Updated Table 5–13 through Table 5–24, and Table 5–27 through
Table 5–30.
■ Added tCOMB information to Table 5–15.
■ Updated Figure 5–6.
■ Added “Referenced Documents” section.
■ Added note to Table 5–1.
■ Added document revision history.
■ Minor content and table updates.
■ Updated “External Timing I/O Delay Adders” section.
■ Updated Table 5–29.
■ Updated Table 5–30.
■ Updated Tables 5-2, 5-4, and 5-12.
■ Updated Figure 5-1.
■ Updated Tables 5-13, 5-16, and 5-26.
■ Removed Note 1 from Table 5-12.
■ Updated the R_PULLUP parameter in Table 5-4.
■ Added Note 2 to Tables 5-8 and 5-9.
■ Updated Table 5-13.
■ Added “Output Drive Characteristics” section.
■ Added I²C mode and Notes 5 and 6 to Table 5-14.
■ Updated timing values to Tables 5-14 through 5-33.
5–25
Summary of Changes
—
—
—
—
Updated document with
MAX IIZ information.
—
—
—
—
—
—
© Novermber 2008 Altera Corporation
MAX II Device Handbook