AK4633EN Datasheet, PDF (57/83 Pages) Asahi Kasei Microsystems – 16-Bit Mono CODEC with ALC & MIC/SPK-AMP

[AK4633]
Addr Register Name
D7
D6
D5
D4
D3
D2
D1
D0
01H Power Management 2
0
0
0
0
M/S
0
MCKO PMPLL
Default
0
0
0
0
0
0
0
0
PMPLL: PLL Block Power Control
0: PLL is Power down and External is selected. (default)
1: PLL is Power up and PLL Mode is selected.
MCKO: Master Clock Output Enable
0: “L” Output (default)
1: 256fs Output
M/S: Master/Slave Mode Select
0: Slave Mode (default)
1: Master Mode
Addr
02H
Register Name
Signal Select 1
Default
D7
D6
D5
D4
D3
SPPSN BEEPS DACS DACA
0
0
0
0
0
0
D2
PMMP
0
D1
MGAIN2
0
D0
MGAIN0
1
MGAIN2, MGAIN0: MIC-Amp Gain Control (Table 18)
MGAIN1 bit is D5 bit of 03H. Default: “001H” (+20.0dB)
PMMP: Power Supply Control for Microphone
0: OFF (default)
1: ON
When PMADC bit is “1”, PMMP bit is enabled.
DACA: Switch Control from DAC to Mono Line Output
0: OFF (default)
1: ON
When PMAO bit is “1”, DACA bit is enabled. When PMAO bit is “0”, the AOUT pin outputs AVSS.
DACS: Switch Control from DAC to Speaker-Amp
0: OFF (default)
1: ON
When DACS bit is “1”, DAC output signal is input to Speaker-Amp.
BEEPS: Switch Control from BEEP pin to Speaker-Amp
0: OFF (default)
1: ON
When BEEPS bit is “1”, BEEP signal is input to Speaker-Amp.
SPPSN: Speaker-Amp Power-Save Mode
0: Power-Save Mode (default)
1: Normal Operation
When SPPSN bit is “0”, Speaker-Amp is in power-save mode. In this mode, the SPP pin goes to Hi-Z and the
SPN pin outputs SVDD/2 voltage. When PMSPK bit = “1”, SPPSN bit is enabled. After the PDN pin is set to
“H”, Speaker-Amp is in power-down mode since PMSPK bit is “0”.
MS0447-E-06
- 57 -
2015/10