|
AK4649 Datasheet, PDF (40/96 Pages) Asahi Kasei Microsystems – 24bit Stereo CODEC with MIC/SPK-AMP | |||
|
◁ |
[AK4649]
â Digital Programmable Filter Circuit
(1) High Pass Filter (HPF2)
Normally, this HPF is used for Wind-Noise Reduction. This is composed 1st order HPF. The coefficient of HPF is set by
F1A13-0 bits and F1B13-0 bits. HPF bit controls ON/OFF of the HPF2. When the HPF2 is OFF, the audio data passes
this block by 0dB gain. The coefficient must be set when HPF bit = â0â or PMPFIL bit = â0â. The HPF2 starts operation
4/fs(max) after when HPF bit=PMPFIL bit= â1â is set.
fs: Sampling frequency
fc: Cut-off frequency
Register setting (Note 36)
HPF: F1A[13:0] bits =A, F1B[13:0] bits =B
(MSB=F1A13, F1B13; LSB=F1A0, F1B0)
1 / tan (Ïfc/fs)
A=
,
1 + 1 / tan (Ïfc/fs)
1 â 1 / tan (Ïfc/fs)
B=
1 + 1 / tan (Ïfc/fs)
Transfer function
1 â z â1
H(z) = A
1 + Bz â1
The cut-off frequency must be set as below.
fc/fs ⥠ï 0.0001 (fc min = 4.41Hz at 44.1kHz)
(2) Low Pass Filter (LPF)
This is composed with 1st order LPF. F2A13-0 bits and F2B13-0 bits set the coefficient of LPF. LPF bit controls ON/OFF
of the LPF. When the LPF is OFF, the audio data passes this block by 0dB gain. The coefficient must be set when LPF bit
= â0â or PMPFIL bit = â0â. The LPF starts operation 4/fs(max) after when LPF bit =PMPFIL bit= â1â is set.
fs: Sampling frequency
fc: Cut-off frequency
Register setting (Note 36)
LPF: F2A[13:0] bits =A, F2B[13:0] bits =B
(MSB=F2A13, F1B13; LSB=F2A0, F2B0)
1
A=
,
1 + 1 / tan (Ïfc/fs)
1 â 1 / tan (Ïfc/fs)
B=
1 + 1 / tan (Ïfc/fs)
Transfer function
1 + z â1
H(z) = A
1 + Bz â1
The cut-off frequency must be set as below.
fc/fs ⥠ï 0.05 (fc min = 2205Hz at 44.1kHz)
MS1023-E-01
- 40 -
2010/08
|
▷ |