|
XC2VP2 Datasheet, PDF (3/430 Pages) Xilinx, Inc – Summary of Features | |||
|
◁ |
R
Virtex-II Pro and Virtex-II Pro X Platform FPGAs: Introduction and Overview
⢠Programmable Receiver Equalization
⢠Internal AC Coupling
⢠On-Chip 50Ω Termination
- Eliminates the need for external termination
resistors
⢠Pre- and Post-Driver Serial and Parallel TX-to-RX
Internal Loopback Modes for Testing Operability
⢠Programmable Comma Detection
- Allows for any protocol
- Allows for detection of any 10-bit character
⢠8B/10B and 64B/66B Encoding Blocks
RocketIO Transceiver Features (All Except XC2VPX20 and XC2VPX70)
⢠Full-Duplex Serial Transceiver (SERDES) Capable of
Baud Rates from 600 Mb/s to 3.125 Gb/s
⢠100 Gb/s Duplex Data Rate (20 Channels)
⢠Monolithic Clock Synthesis and Clock Recovery (CDR)
⢠Fibre Channel, 10G Fibre Channel, Gigabit Ethernet,
10 Gb Attachment Unit Interface (XAUI), and
Infiniband-Compliant Transceivers
⢠8-, 16-, or 32-bit Selectable Internal FPGA Interface
⢠8B /10B Encoder and Decoder (optional)
⢠50Ω /75Ω on-chip Selectable Transmit and Receive
Terminations
⢠Programmable Comma Detection
⢠Channel Bonding Support (from 2 to 20 Channels)
⢠Rate Matching via Insertion/Deletion Characters
⢠Four Levels of Selectable Pre-Emphasis
⢠Five Levels of Output Differential Voltage
⢠Per-Channel Internal Loopback Modes
⢠2.5V Transceiver Supply Voltage
PowerPC RISC Processor Block Features (All Except XC2VP2)
⢠Embedded 300+ MHz Harvard Architecture Block
⢠Low Power Consumption: 0.9 mW/MHz
⢠Five-Stage Data Path Pipeline
⢠Hardware Multiply/Divide Unit
⢠Thirty-Two 32-bit General Purpose Registers
⢠16 KB Two-Way Set-Associative Instruction Cache
⢠16 KB Two-Way Set-Associative Data Cache
⢠Memory Management Unit (MMU)
- 64-entry unified Translation Look-aside Buffers (TLB)
- Variable page sizes (1 KB to 16 MB)
⢠Dedicated On-Chip Memory (OCM) Interface
⢠Supports IBM CoreConnect⢠Bus Architecture
⢠Debug and Trace Support
⢠Timer Facilities
Virtex-II Pro Platform FPGA Technology (All Devices)
⢠SelectRAM+ Memory Hierarchy
- Up to 8 Mb of True Dual-Port RAM in 18 Kb block
SelectRAM+ resources
- Up to 1,378 Kb of distributed SelectRAM+
resources
- High-performance interfaces to external memory
⢠Arithmetic Functions
- Dedicated 18-bit x 18-bit multiplier blocks
- Fast look-ahead carry logic chains
⢠Flexible Logic Resources
- Up to 88,192 internal registers/latches with Clock
Enable
- Up to 88,192 look-up tables (LUTs) or cascadable
variable (1 to 16 bits) shift registers
- Wide multiplexers and wide-input function support
- Horizontal cascade chain and Sum-of-Products
support
- Internal 3-state busing
⢠High-Performance Clock Management Circuitry
- Up to twelve Digital Clock Manager (DCM) modules
· Precise clock de-skew
· Flexible frequency synthesis
· High-resolution phase shifting
- 16 global clock multiplexer buffers in all parts
⢠Active Interconnect Technology
- Fourth-generation segmented routing structure
- Fast, predictable routing delay, independent of
fanout
- Deep sub-micron noise immunity benefits
⢠SelectIOâ¢-Ultra Technology
- Up to 1,164 user I/Os
- Twenty-two single-ended standards and
ten differential standards
- Programmable LVCMOS sink/source current (2 mA
to 24 mA) per I/O
- XCITE Digitally Controlled Impedance (DCI) I/O
- PCI/ PCI-X support (1)
- Differential signaling
· 840 Mb/s Low-Voltage Differential Signaling I/O
(LVDS) with current mode drivers
· On-chip differential termination
· Bus LVDS I/O
1. Refer to XAPP653 for more information.
DS083 (v4.7) November 5, 2007
Product Specification
www.xilinx.com
Module 1 of 4
2
|
▷ |