COM20022I-3.3V Datasheet, PDF (37/73 Pages) SMSC Corporation – 10 Mbps ARCNET (ANSI 878.1) Controller with 2Kx8 On-Chip RAM

10 Mbps ARCNET (ANSI 878.1) Controller with 2Kx8 On-Chip RAM
Datasheet
BIT
BIT NAME
7 Read Bus Timing
Select
6 Reserved
5,4 Clock Multiplier
Table 6.13 - Setup 2 Register
SYMBOL
DESCRIPTION
RBUSTMG This bit is used to Disable/Enable the High Speed CPU
Read function for High Speed CPU bus support.
RBUSTMG=0: Disable (Default), RBUSTMG=1: Enable.
That is, if BUSTMG (pin 26) = 1 and RBUSTMG = 1, High
Speed CPU Read operations are enabled. It does not
influence write operation. High speed CPU Read operation
is only for non-multiplexed bus.
This bit is undefined. It must be 0.
CKUP1, 0
Higher frequency clocks are generated from the 20 MHz
crystal through the selection of these two bits as shown.
This clock multiplier is powered-down on default. After
changing the CKUP1 and CKUP0 bits, the ARCNET core
operation is stopped and the internal PLL in the clock
multiplier is awakened and it starts to generate the 40 MHz.
The lock out time of the internal PLL is 8μSec typically.
After 1 mS it is necessary to write command data '18H' to
command register for re-starting the ARCNET core
operation. EF bit must be ‘1’ if the data rate is over 5Mbps.
CAUTION: Changing the CKUP1 and CKUP0 bits must be
one time or less after releasing a hardware reset.
3 Enhanced
Functions
2 No Synchronous
EF
NOSYNC
CKUP1
CKUP0 Clock Frequency (Data Rate)
0
0
20 MHz (Up to 2.5Mbps) Default
0
1
40 MHz (Up to 5Mbps)
1
0
Reserved
1
1
80 MHz (Only 10Mbps)
Note: After changing the CKUP1 or CKUP0 bits, it is
necessary to write a command data '18H' to the
command register. Because after changing the
CKUP [1, 0] bits, the internal operation is stopped
temporarily. The writing of the command is to start
the operation.
These initializing steps are shown below.
1. Hardware reset (Power ON)
2. Change CKUP[1, 0] bit
3. Wait 1mSec (wait until stable oscillation)
4. Write command '18H' (start internal operation)
5. Start initializing routine (Execute existing software)
This bit is used to enable the new enhanced functions in the
COM20022I 3V. EF = 0: Disable (Default), EF = 1: Enable.
If EF = 0, the timing and function is the same as in the
COM20020, Revision B. See appendix “A”. EF bit must be
‘1’ if the data rate is over 5Mbps.
EF bit should be ‘1’ for new design customers.
EF bit should be ‘0’ for replacement customers.
This bit is used to enable the SYNC command during
initialization. NOSYNC= 0, Enable (Default) The line must
be idle for the RAM initialization sequence to be written.
NOSYNC= 1, Disable:) The line does not have to be idle for
the RAM initialization sequence to be written. See appendix
“A”.
SMSC COM20022I 3.3V Rev.C
Page 37
DATASHEET
Revision 03-08-07