91C100FDREVB Datasheet, PDF (19/68 Pages) SMSC Corporation – FEAST FAST ETHERNET CONTROLLER WITH FULL DUPLEX CAPABILITY

BANK SELECT REGISTER
OFFSET
E
NAME
BANK SELECT
REGISTER
TYPE
READ/WRITE
SYMBOL
BSR
HIGH
0
0
1
1
0
0
1
1
BYTE
0
0
1
1
0
0
1
1
LOW
BYTE
BS2
BS1
BS0
X
X
X
X
X
0
0
0
BS2, BS1, BS0 Determine the bank presently in use. This register is always accessible and is used to select the
register bank in use.
The upper byte always reads as 33h and can be used to help determine the I/O location of the LAN91C100FD.
The BANK SELECT REGISTER is always accessible regardless of the value of BS0-2.
Note that the bank select register can be accessed as a doubleword at offset Ch, as a word at offset Eh, or as at
offset Fh, however a doubleword write to offset Ch will write the BANK SELECT REGISTER but will not write the
registers Ch and Dh.
BANK 7 has no internal registers other than the BANK SELECT REGISTER itself. On valid cycles where BANK7 is
selected (BS0=BS1=BS2=1), and A3=0, nCSOUT is activated to facilitate implementation of external registers.
Note: BANK7 does not exist in LAN91C9x devices. For backward S/W compatibility BANK7 accesses should be done
if the Revision Control register indicates the device is the LAN91C100FD.
BANK 0
OFFSET
0
NAME
TRANSMIT CONTROL
REGISTER
TYPE
READ/WRITE
SYMBOL
TCR
This register holds bits programmed by the CPU to control some of the protocol transmit options.
HIGH
BYTE
SWFDUP
0
0
0
LOW
BYTE
PAD_EN
0
0
0
EPH
LOOP
0
0
0
STP
SQET
0
0
0
FDUPLX
0
0
0
MON_
CSN
0
FORCOL
0
0
0
LOOP
0
NOCRC
0
TXENA
0
SWFDUP - Enables Switched Full Duplex mode. In this mode, transmit state machine is inhibited from recognizing carrier
sense, so deferrals will not occur. Also inhibits collision count, therefore, the collision related status bits in the EPHSR are
not valid (CTR_ROL, LATCOL, SQET, 16COL, MUL COL, and SNGL COL). Uses COL100 as flow control, limiting
backoff and jam to 1 clock each before inter-frame gap, then retry will occur after IFG. If COL100 is active during
preamble, full preamble will be output before jam. When SWFDUP is high, the values of FDUPLX and MON_CSN have no
effect. This bit should be low for non-MII operation.
EPH_LOOP - Internal loopback at the EPH block. Serial data is internally looped back when set. Defaults low. When
EPH_LOOP is high the following transmit outputs are forced inactive: TXD0-TXD3 = 0h, TXEN100 = TXEN = 0, TXD = 1.
The following and external inputs are blocked: CRS=CRS100=0, COL=COL100=0, RX_DV= RX_ER=0.
SMSC DS – LAN91C100FD REV. B
Page 19
Rev. 05/31/2000