LAN9312 Datasheet, PDF (118/458 Pages) SMSC Corporation – High Performance Two Port 10/100 Managed Ethernet Switch with 32-Bit Non-PCI CPU Interface

High Performance Two Port 10/100 Managed Ethernet Switch with 32-Bit Non-PCI CPU Interface
Datasheet
The Filter i Offset register defines the offset in the frame’s destination address field from which the
frames are examined by Filter i. Table 9.5 describes the Filter i Offset bit fields.
FIELD
7:0
Table 9.5 Filter i Offset Bit Definitions
FILTER i OFFSET DESCRIPTION
DESCRIPTION
Pattern Offset: The offset of the first byte in the frame on which CRC is checked for wake-up frame
recognition. The minimum value of this field must be 12 since there should be no CRC check for
the destination address and the source address fields. The Host MAC checks the first offset byte
of the frame for CRC and checks to determine whether the frame is a wake-up frame. Offset 0 is
the first byte of the incoming frame's destination address.
The Filter i CRC-16 register contains the CRC-16 result of the frame that should pass Filter i.
Table 9.6 describes the Filter i CRC-16 bit fields.
FIELD
15:0
Table 9.6 Filter i CRC-16 Bit Definitions
FILTER i CRC-16 DESCRIPTION
DESCRIPTION
Pattern CRC-16: This field contains the 16-bit CRC value from the pattern and the byte mask
programmed to the wake-up filter register function. This value is compared against the CRC
calculated on the incoming frame, and a match indicates the reception of a wakeup frame.
9.5.1
Magic Packet Detection
Setting the Magic Packet Enable bit (MPEN) in the Host MAC Wake-up Control and Status Register
(HMAC_WUCSR) places the Host MAC in the “Magic Packet” detection mode. In this mode, normal
data reception is disabled, and detection logic within the Host MAC examines received data for a Magic
Packet. The LAN9312 can be programmed to notify the host of the “Magic Packet” detection with the
assertion of the host interrupt (IRQ) or power management event signal (PME). Upon detection, the
Magic Packet Received bit (MPR) in the HMAC_WUCSR register is set. When the host clears the
MPEN bit, the Host MAC will resume normal receive operation. Please refer to Section 14.3.12, "Host
MAC Wake-up Control and Status Register (HMAC_WUCSR)," on page 285 for additional information
on this register.
In Magic Packet mode, the Host MAC constantly monitors each frame addressed to the node for a
specific Magic Packet pattern. Only packets matching the Host MAC address or broadcast address are
checked for the Magic Packet requirements. Once the address requirement has been met, the Host
MAC checks the received frame for the pattern 48’hFF_FF_FF_FF_FF_FF after the destination and
source address field. The Host MAC then looks in the frame for 16 repetitions of the Host MAC address
without any breaks or interruptions. In case of a break in the 16 address repetitions, the Host MAC
again scans for the 48'hFF_FF_FF_FF_FF_FF pattern in the incoming frame. The 16 repetitions may
be anywhere in the frame but must be preceded by the synchronization stream. The device will also
accept a multicast frame, as long as it detects the 16 duplications of the Host MAC address.
For example, if the Host MAC address is 00h 11h 22h 33h 44h 55h, then the MAC scans for the
following data sequence in an Ethernet frame:
Revision 1.2 (04-08-08)
118
DATASHEET
SMSC LAN9312