M3727GM6 Datasheet, PDF (95/129 Pages) Renesas Technology Corp – SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER with CLOSED CAPTION DECODER and ON-SCREEN DISPLAY CONTROLLER

M3727GM6/M8–XXXSP/FP M37272E8SP/FP
8.15 DISPLAY OSCILLATION CIRCUIT
The OSD oscillation circuit has a built-in clock oscillation circuits, so
that a clock for OSD can be obtained simply by connecting an LC, a
ceramic resonator, or a quartz-crystal oscillator across the pins OSC1
and OSC2. Which of the sub-clock or the OSD oscillation circuit is
selected by setting bits 5 and 6 of the OSD control register (address
00D016).
OSC1 OSC2
L
C1
C2
Fig.8.15.1 Display Oscillation Circuit
8.16 AUTO-CLEAR CIRCUIT
When a power source is supplied, the auto-clear function will oper-
ate by connecting the following circuit to the RESET pin.
Circuit example 1
Vcc
RESET
Vss
Circuit example 2
8.17 ADDRESSING MODE
The memory access is reinforced with 17 kinds of addressing modes.
Refer to SERIES 740 <Software> User’s Manual for details.
8.18 MACHINE INSTRUCTIONS
There are 71 machine instructions. Refer to SERIES 740 <Soft- ware>
User’s Manual for details.
9. PROGRAMMING NOTES
• The divide ratio of the timer is 1/(n+1).
• Even though the BBC and BBS instructions are executed imme-
diately after the interrupt request bits are modified (by the pro-
gram), those instructions are only valid for the contents before
the modification. At least one instruction cycle is needed (such as
an NOP) between the modification of the interrupt request bits
and the execution of the BBC and BBS instructions.
• After the ADC and SBC instructions are executed (in the decimal
mode), one instruction cycle (such as an NOP) is needed before
the SEC, CLC, or CLD instruction is executed.
• An NOP instruction is needed immediately after the execution of
a PLP instruction.
• In order to avoid noise and latch-up, connect a bypass capacitor
(≈ 0.1µF) directly between the VCC pin–VSS pin, AVCC pin–VSS
pin, and the VCC pin–CNVSS pin, using a thick wire.
• M3727GM6/M8-XXXSP and M37272E8SP/FP are compatible, but
please attention differences as follows:
Parameter
M37272E8SP/FP
Spec of1 4th pins
AVcc
Power souce voltage
When System operate
Normal
f(XIN) : 8MFz
OSD : OFF
Data slicer : OFF
15 mA
Max.
30 mA
OSD : ON
Data slicer : ON
30mA
45 mA
M3727GM6/M8-XXXSP/FP
NC (Non connection)
Normal Max.
10 mA 25 mA
25 mA 40 mA
✽ Need to apply 5V±10%, because 14th pin of M37272E8SP/FP
is AVcc pin.
M3727GM6/M8-XXXSP/FP is the non connection pin, but it is
not connect to the inside of IC. You can apply voltage.
Vcc
RESET
Vss
Note : Make the level change from “L” to “H” at the point at
which the power source voltage exceeds the specified
voltage.
Fig.8.16.1 Auto-clear Circuit Example
Rev.1.00 Apr 01, 2001 page 95 of 127
REJ03B0132-0100Z