R-IN32M3 Datasheet, PDF (69/116 Pages) Renesas Technology Corp – LSI for Industrial Ethernet

R-IN32M3 Series Data Sheet
4. Electrical Specifications
Table 4.3 Terms Used for DC Characteristics
Parameter
Off-state output current
Output short circuit
current
Input leakage current
Output current, low
Output current, high
Output voltage, low
Output voltage, high
Symbol
IOZ
IOS
ILI
IOL
IOH
VOL
VOH
Meaning
Indicates the current that flows from the power supply pins when the rated power
supply voltage is applied when a 3-state output has high impedance.
Indicates the current that flows when the output pins are shorted (to GND pins)
when output is at high level.
Indicates the current that flows via an input pin when a voltage is applied to that
pin.
Indicates the current that flows to the output pins when the rated low-level output
voltage is being applied.
Indicates the current that flows from the output pins when the rated high-level
output voltage is being applied.
Indicates the output voltage at low level and when the output pin is open.
Indicates the output voltage at high level and when the output pin is open.
4.2 Absolute Maximum Ratings
Table4.4 Absolute Maximum Ratings
Parameter
Power supply voltage
Symbol
VDD
I/O voltage
VI /VO
Output current (3.3 V buffer)
IO
Output current (5V-Tolerant buffer) IO
Operating ambient temperature
TA
Storage temperature
Tstg
Conditions
1.0V type
3.3 V type
3.3 V buffer VI /VO < VDD + 0.5V
5V-Tolerant buffer VI /VO < VDD + 3.0V
6 mA type
12 mA type
4 mA type
-
-
Ratings
-0.5 to +1.4
-0.5 to +4.6
-0.5 to +4.6
-0.5 to +6.6
15
25
10.35
-40 to +85
-65 to +125
Unit
V
V
V
V
mA
mA
mA
°C
°C
Caution: ^{Product quality may suffer if the absolute maximum rating is exceeded even momentarily for}
any parameter. That is, the absolute maximum ratings are rated values at which the product
is on the verge of suffering physical damage, and therefore the product must be used under
conditions that ensure that the absolute maximum ratings are not exceeded.
Remark: 3.3 V must be applied to the I/O pins only after applying the power supply voltage.
R18DS0008EJ0401
Feb 28, 2017
Page 69 of 110