R-IN32M3 Datasheet, PDF (114/116 Pages) Renesas Technology Corp – LSI for Industrial Ethernet

R-IN32M3 Series Data Sheet
REVISION HISTORY
Rev.
4.00
4.01
Date
Nov 30,2015
Feb 28, 2017
Description
Page
Summary
42 Modify “Recommended connection when not in use” at 2.4.6 Operating Mode
Setting Signals.
46 Modify “Table3.1” at 3.3 EtherCAT Slave Controller Function.
51 Add “External event count function” at 3.8.1 Features.
65-66 Modify “QINT” and add “Remark” at 3.20.1 Features.
72 Add 4.6 Terminal Capacity Values.
74 Modify “MAX” values for CCI_CLK2_097M at 4.8.1(1) Input clock
characteristics.
78-82 Modify a Note for Figure4.4, Figure4.5 and Add WAITZ1-WAITZ3 for Figure4.6,
Figure4.7 at 4.8.3(3) Synchronous burst access MEMC access timing.
100 Modify “Symbol” for DMAACKZn, RTDMAACKZoutput low level width at 4.8.6
External DMA Interface.
101-102 Add “Symbol” for CSISCKn output high/low level width and “Remark” at 4.8.7
CSI Interface.
105-106 Modify the signals “ETHn_RXDm” at 4.8.10 Ethernet Interface.
107 Modify “Parameter” and “MAX” value for TRACEDATA output delay time at
4.8.11(2) Trace interface.
30 Modify description of the CCM_MDIN0-3 signals at 2.3.15
CC-Link Pins (Intelligent Device Station). (complement)
58 Modify interface system, synchronous relationship, and buffers at 3.14.1(1)
External MCU Interface. (complement)
59 Modify description of address conversion at 3.14.1(2) AHB master port
function. (expression alignment)
Explicitly notate applicable modes at 3.14.1(3) Status check function.
(complement)
60 Change from "state" to "wait" at 3.15.1 Features. (expression alignment)
61 Change pin names for wait signal at 3.16.1 Features. (error correction)
62 Add the ECC error interrupt function at 3.17.1 Features. (new function)
Correct operation of the AHB bus at occurrence of a 2-bit ECC error at 3.17.2
Read Buffer. (error correction)
63 Change expression of Header Endec at 3.18 Data RAM. (expression
alignment)
Add an ECC error interrupt function at 3.18.1 Features. (new function)
64 Add an ECC error interrupt function at 3.19.1 Features. (new function)
65 Add a supported function "Internal DMA/Buffer Allocator/Header EnDec" at
3.20.1 Features. (new function)
71 Delete the column of 5kΩ resistor from Table 4.6 Input leakage current (error
correction) and modify the symbol for the voltage of high-level output (IOL→IOH)
in Table 4.7 (error correction) at 4.4 DC Characteristics.
C-4