R-IN32M3 Datasheet, PDF (113/116 Pages) Renesas Technology Corp – LSI for Industrial Ethernet

R-IN32M3 Series Data Sheet
REVISION HISTORY
Rev.
2.01
2.02
2.03
2.04
3.00
3.01
4.00
Date
Feb 07 ,2014
Apr 18 ,2014
May 30 ,2014
Dec 25 ,2014
Aug 31,2015
Sep 18,2015
Nov 30,2015
Page
6, 10
30
33
37
39
72
71
86
overall
39
73
3
6 to 10
31
76
86
83 to 93
88 to 91
14 to 36
15
19
27
29
30
31
32
36
39
Description
Summary
Modification of the accessible area of EtherCAT of 1.5 Memory Map
Add CCM_CLK80M pins to list of 2.3.16 CC-Link Signals (Remote device
station)
Modification of Boot mode select of 2.3.19 Operation mode Setting Signals
Addition the resister value for Pull-up/down
Modification of title name of 2.4.8 CC-Link Signal (Intelligent device station,
Remote device station)
Delete the description of 5kΩ row of 4.5 Pull-up/down Resister Values
Addition Table4.6 DC Characteristics TYP value
Addition the description at 4.7.5 Serial flash ROM interface
Modification of CC-Link Signals (Remote device station)
Modification of the description about ‘recommended connection’ and addition a
caution description at 2.4.7 CC-Link IE Field Signal
Add a notes of “4.6 Power-on-off sequence”
Change status for Intelligent device station for CC-Link in 1.3 Overview
Modification of the accessible area of EtherCAT of 1.5 Memory Map
Modify the property for FB pin from “-” to “Input”
Modify the description of MIN value for low level width in 4.7.2 Reset signals
Add description for “Asynchronous mode” in 4.7.4 External microcomputer
interface signal.
Correction the timing information of 4.7.4 External Microcomputer Interface
Signal
Add description for “Synchronous mode (CC-Link IE Field)” in 4.7.4 External
microcomputer interface signal.
Add description of “Symbol and Abbreviation”, port functions of synchronous
burst access memory controller at 2.3 Signals by Function.
Add a Note of Ethernet Transmit ports at 2.3.1(1) PHY Interface.
Modify the “Level during reset” for BUSCLK and add Note1 at 2.3.3 External
Memory Interface Signals.
Modify the “Level during reset” for TRACECLK at 2.3.11 Trace Signals.
Add a Note for CCI_WAITEDGEH and CCI_WRLENH at 2.3.14 CC-Link IE
Field (Intelligent device station) Signals.
Modify the “Function” for CCM_CLK80M at 2.3.15 CC-Link Signals
(Intelligent device station).
Add a Note2 for CCM_CLK80M at 2.3.16 CC-Link Signals (Remote device
station).
Modify the “Function” for XT1/XT2, OSCTH, JTAGSEL and “Active” for OSCTH
and “Level during reset” for RSTOUTZ, CLKOUT25M0/1 at 2.3.17 System
Signals.
Add the combinations of available operating mode at 2.3.19 Operation Mode
Setting Signal.
Modify “I/O” for XT2 and “Recommended connection when not in use” for
OSCTH, JTAGSEL at 2.4.3 System Signals.
C-3