R01DS0190EJ0100 Datasheet, PDF (58/110 Pages) Renesas Technology Corp – 32 MHz 32-bit RX MCUs, 50 DMIPS, up to 128 Kbytes of flash memory

RX111 Group
5. Electrical Characteristics
Table 5.14 DC Characteristics (12)
Conditions: VCC = AVCC0 = VCC_USB = 1.8 to 3.6 V, VSS = AVSS0 = VREFL0 = VSS_USB = 0 V, T_a = –40 to +105°C
The ripple voltage must meet the allowable ripple frequency f_r(VCC) within the range between the VCC upper limit
(3.6 V) and lower limit (1.8 V).
When VCC change exceeds VCC ±10%, the allowable voltage change rising/falling gradient dt/dVCC must be met.
Item
Symbol Min. Typ. Max. Unit
Test Conditions
Allowable ripple frequency
Allowable voltage change rising/
falling gradient
f_{r (VCC)}
—
—
10
kHz
Figure 5.6
V_{r (VCC)} ≤ VCC × 0.2
—
—
1
MHz
Figure 5.6
V_{r (VCC)} ≤ VCC × 0.08
—
—
10
MHz
Figure 5.6
V_{r (VCC)} ≤ VCC × 0.06
dt/dVCC 1.0
—
—
ms/V When VCC change exceeds VCC ±10%
VCC
1/f_r(VCC)
V_r(VCC)
Figure 5.6 Ripple Waveform
Table 5.15 DC Characteristics (13)
Conditions: VCC = AVCC0 = VCC_USB = 1.8 to 3.6 V, VSS = AVSS0 = VREFL0 = VSS_USB = 0 V, T_a = –40 to +105°C
Item
Symbol
Min.
Typ.
Max.
Unit
Test Conditions
Permissible error of VCL pin external
C_VCL
1.4
4.7
7.0
μF
capacitance
Note: • The recommended capacitance is 4.7 μF. Variations in connected capacitors should be within the above range.
R01DS0190EJ0100 Rev.1.00
Jun 19, 2013
Page 58 of 107