M32C82_15 Datasheet, PDF (46/84 Pages) Renesas Technology Corp – SINGLE-CHIP 16/32-BIT CMOS MICROCOMPUTER

M32C/82 Group
5. Electrical Characteristics (VCC = 5 V)
VCC = 5V
Table 5.3 Electrical Characteristics (VCC=4.2 to 5.5V, VSS=0V at Topr= –20 to 85^oC
unless otherwise specified)
Symbol
VOH
Output high ("H")
voltage
Parameter
Condition
P00-P07, P10-P17, P20-P27, P30-P37, P40-P47, P50- VCC=5V
P57, P60-P67, P72-P77, P80-P84, P86, P87, P90-P97, ^IOH=-5mA
P100-P107, P110-P114, P120-P127, P130-P137,
P140-P146, P150-P157(1)
P00-P07, P10-P17, P20-P27, P30-P37, P40-P47, P50- VCC=5V
P57, P60-P67, P72-P77, P80-P84, P86, P87, P90-P97, ^{IOH=-200µA}
P100-P107, P110-P114, P120-P127, P130-P137,
P140-P146, P150-P157(1)
XOUT
VCC=5V
IOH=-1mA
XCOUT
No load applied
Standard
Unit
Min Typ Max
3.0
V
4.7
V
3.0
V
3.3
V
VOL
Output low ("L")
voltage
P00-P07, P10-P17, P20-P27, P30-P37, P40-P47, P50- IOL=5mA
P57, P60-P67, P70-P77, P80-P84, P86, P87, P90-P97,
P100-P107, P110-P114, P120-P127, P130-P137,
P140-P146, P150-P157(1)
P00-P07, P10-P17, P20-P27, P30-P37, P40-P47, P50- IOL=200µA
P57, P60-P67, P70-P77, P80-P84, P86, P87, P90-P97,
P100-P107, P110-P114, P120-P127, P130-P137,
P140-P146, P150-P157(1)
XOUT
IOL=1mA
2.0 V
0.45 V
2.0 V
XCOUT
No load applied
0
V
VT+-VT- Hysteresis
HOLD, RDY, TA0IN-TA4IN, TB0IN-TB5IN, INT0-INT5,
ADTRG, CTS0-CTS4, CLK0-CLK4, TA0OUT-TA4OUT,
NMI, KI0-KI3, RxD0-RxD4, SCL0-SCL4, SDA0-
SDA4
RESET
IIH
Input high ("H")
P00-P07, P10-P17, P20-P27, P30-P37, P40-P47, P50- VI=VCC
current
P57, P60-P67, P70-P77, P80-P87, P90-P97, P100-
P107, P110-P114, P120-P127, P130-P137, P140-
P146, P150-P157(1), XIN, RESET, CNVSS, BYTE
IIL
Input low ("L") current P00-P07, P10-P17, P20-P27, P30-P37, P40-P47, P50- VI=0V
P57, P60-P67, P70-P77, P80-P87, P90-P97, P100-
P107, P110-P114, P120-P127, P130-P137, P140-
P146, P150-P157(1), XIN, RESET, CNVSS, BYTE
RPULLUP Pull-up resistance P00-P07, P10-P17, P20-P27, P30-P37, P40-P47, P50- VI=0V
P57, P60-P67, P72-P77, P80-P84, P86, P87, P90-P97,
P100-P107, P110-P114, P120-P127, P130-P137,
P140-P146, P150-P157(1)
RfXIN Feedback resistance XIN
RfXCIN Feedback resistance XCIN
VRAM RAM standby voltage Through VDC
ICC
Power supply current Measurement conditions:
f(XIN)=30 MHz, square wave,
In single-chip mode, output no division
pins are left open and other
pins are connected to VSS.
f(XCIN)=32 kHz, with a wait state,
Topr=25° C
Topr=25° C when the clock stops
NOTES:
1. P11 to P15 are provided in the 144-pin package only.
0.2
1.0 V
0.2
1.8 V
5.0 µA
-5.0 µA
30 50 167 kΩ
1.5
10
2.5
28
MΩ
MΩ
V
54 mA
470
µA
0.4 20 µA
Rev.1.20 Jun. 01, 2004 page 44 of 80