MN63Y1208 Datasheet, PDF (92/120 Pages) Panasonic Semiconductor – Built-in 4-Kbit FeRAM non-volatile memory with fast write and low power consumption

Chapter 7 Tunnel Mode
7.4 Command
The tunnel mode commands supported by this RFID fall into two types:
RF-interface-side commands between reader/writer and RFID and serial-interface-side commands between
the host and RFID.
These commands are shown in Table 7-2 and Table 7-3.
Subsequent sections describe each command in detail.
Name
READ
WRITE
Table 7-2 RF Interface Command List in Tunnel Mode
Code
JISX6319-4
ISO/IEC
14443TypeB
0x06
0xB0
0x08
0xD6
Description
Reads data of the host from reader/writer.
(Command code is the same as that for RF
communication mode)
Writes data to the host from reader/writer.
(Command code is the same as that for RF
communication mode)
Table 7-3 Serial-Communication-Side Commands List in Tunnel Mode
Name
QUERY
ANSWER (normal
end)
ANSWER (error)
Code
0x28
0xF8
0xE8
Descripion
The host inquires about the content of tunnel mode
command to RFID.
The host reports the processing result (normal end) of
tunnel mode command to RFID.
The host reports the processing result (error) of tunnel
mode command to RFID.
92