MN63Y1208 Datasheet, PDF (60/120 Pages) Panasonic Semiconductor – Built-in 4-Kbit FeRAM non-volatile memory with fast write and low power consumption

Chapter 4 RF Communication Mode
4.3.9 Command
The commands based on ISO/IEC14443 TypeB supported by this RFID fall into two types:
Commands defined in ISO/IEC14443-3, and APDU commands defined in ISO/IEC7816-4 to be sent in the
ISO/IEC14443-4 format.
These commands are shown in Table 4-22 and Table 4-23.
For information about the command format, see Section 4.3.2 Frame Format and Section 4.3.5 Upper
Command Format.
Additionally, protocol control such as chaining, ACK/NAK response (R-Block), and DESELECT (S-Block) are
also supported. For its detail, see Section 4.3.3 Protocol Control.
Subsequent sections describe each command in detail.
Table 4-22 ISO/IEC14443-3 TypeB Command List
Name
Code
Description
REQB/WUPB
0x05 Identifies the RFID. Used by reader/writer.
ATTRIB
HLTB
0x1D
0x50
Exchanges protocol signal information between reader/writer and
RFID, and causes the RFID to transition to the state in which
command processing is enabled.
Transitions the RFID to a HALT state. Used by reader/writer.
Name
SELECT
READ
WRITE
INS
0xA4
0xB0
0xD6
Table 4-23 APDU Command List
Description
Selects the file. (No processing is performed in this RFID.
Reads the data of RFID from reader/writer. While in tunnel mode,
reads the data of the host from reader/writer.
Writes a data to RFID from reader/writer. While in tunnel mode,
writes a data to the host.
60