MN63Y1208 Datasheet, PDF (2/120 Pages) Panasonic Semiconductor – Built-in 4-Kbit FeRAM non-volatile memory with fast write and low power consumption

About this manual
Organization
These specifications provide important information for users of the MN63Y1007E1, including an overview and
descriptions of functions.
Manual Configuration
Each section of this manual consists of a title, main text, and notes. The layout and definition of each section
are shown below.
1.1 UART
This section describes the UART specification.
1.1.1 Communication Specifications
Table 1-1 shows the UART specification of this RFID.
Table 1-1 UART Communication Specification
Data transfer
method
Data rate
Asynchronous, half-duplex (Only IRQ notification allows full-
DUMMY duplex)
1200 bps, 2400 bps, 4800 bps, 9600 bps, 19200 bps, 38400
bps
Character
transmission
xLSB-first
xData (8 bits)
xStart bit (1bit)
xParity bit (1bit, even)
xStop bit (1bit) See Note below.
Other
No flow control signal (RTS/CTS)
Middle title
Small title
Text
Note: In order to ensure the timing margin, when sending consequtive data from the host, use a
2-bit stop bit or set the interval between stop bit and next start bit to 1 bit or more.
Note
This is the Note.
Please read.
Finding Desired Information
This manual provides two methods for finding desired information quickly and easily.
1. Consult the table of contents at the front of the manual to locate desired titles.
2. Chapter names are located at the top outer corner of each page, and section titles are located at the
bottom outer corner of each page.
2