MN63Y1208 Datasheet, PDF (59/120 Pages) Panasonic Semiconductor – Built-in 4-Kbit FeRAM non-volatile memory with fast write and low power consumption

Chapter 4 RF Communication Mode
4.3.8.7 Status Word
Table 4-21 lists the meaning of statuses.
Table 4-21 Status Word
SW1
SW2
Meaning
Description
0x90
0x00
Normal end
Terminated normally.
0x50
0x00
Tunnel mode error No response from the host
0x51
0x00
Tunnel mode error The host responded with an error.
0x67
0x00
Lc/Le specification error x Lc and Le were out of the specification.
(*1)
x In encrypted communication, Lc and Le were not
16×n bytes.
0x6A
0x86
P1-P2 specification error
x Bit 7 of P1 was not 0. (*2)
x Illegal mode setting (RFU setting)
x Specified outside FeRAM
x In encrypted communication, the address was not
specified in 16×n byte units.
0x6D
0x00
INS specification error Illegal INS setting (Specified an unimplemented
command)
0x6E
0x00 CLA specification error Illegal CLA setting (except 0x00)
0x6F
0x00
Self-diagnosis error
(*1)
x Write access to FeRAM-Read-Only area (RORF
setting)
x Plaintext (unencrypted) command access to
Encrypted-communication-enable-only area
(SECURITY setting)
(*1) For more information about these errors, see the Administrator's Manual.
(*2) In the case of SELECT command, it may become "Lc, Le error 0x6700" depending on the combination of
values of P1,P2.
59