MC68HC05T16 Datasheet, PDF(31/128 Page) Motorola, Inc – High-density complementary metal oxide semiconductor (HCMOS) microcontroller unit

English

English German Russian Spanish Italian Polish Chinese Japanese Korean French Portuguese	Language :

MC68HC05T16 Datasheet, PDF (31/128 Pages) Motorola, Inc – High-density complementary metal oxide semiconductor (HCMOS) microcontroller unit

◁

RESETS AND INTERRUPTS

4.1

RESETS

The MC68HC05T16 can be reset in three ways: by the initial power-on reset function, by an active

low input to the RESET pin, and by a COP watchdog timer reset (if enabled). Any of these resets

will cause the program to go to its starting address, speciï¬ed by the contents of memory locations

$FFFE and $FFFF, and cause the interrupt mask of the Condition Code register to be set.

4.1.1 Power-On Reset (POR)

The power-on reset occurs when a positive transition is detected on the supply voltage, VDD. The

power-on reset is used strictly for power-up conditions, and should not be used to detect any drops

in the power supply voltage. There is no provision for a power-down reset. The power-on circuitry

provides for a 4064 tcyc delay from the time that the oscillator becomes active. If the external

RESET pin is low at the end of the 4064 tcyc time out, the processor remains in the reset condition

until RESET goes high. The user must ensure that VDD has risen to a point where the MCU can

operate properly prior to the time the 4064 POR cycles have elapsed. If there is doubt, the external

RESET pin should remain low until such time that VDD has risen to the minimum operating voltage

speciï¬ed.

4.1.2 RESET Pin

The RESET input pin is used to reset the MCU to provide an orderly software start-up procedure.

When using the external reset, the RESET pin must stay low for a minimum of 1.5tcyc. The

RESET pin contains an internal Schmitt Trigger as part of its input to improve noise immunity.

MC68HC05T16

RESETS AND INTERRUPTS

TPG

MOTOROLA

4-1

▷