English
Language : 

PIC16F882_09 Datasheet, PDF (85/328 Pages) Microchip Technology – 28/40/44-Pin, Enhanced Flash-Based 8-Bit CMOS Microcontrollers with nanoWatt Technology
PIC16F882/883/884/886/887
8.0 COMPARATOR MODULE
Comparators are used to interface analog circuits to a
digital circuit by comparing two analog voltages and
providing a digital indication of their relative magnitudes.
The comparators are very useful mixed signal building
blocks because they provide analog functionality
independent of the program execution. The analog
comparator module includes the following features:
• Independent comparator control
• Programmable input selection
• Comparator output is available internally/externally
• Programmable output polarity
• Interrupt-on-change
• Wake-up from Sleep
• PWM shutdown
• Timer1 gate (count enable)
• Output synchronization to Timer1 clock input
• SR Latch
• Programmable and fixed voltage reference
Note: Only Comparator C2 can be linked to
Timer1.
8.1 Comparator Overview
A single comparator is shown in Figure 8-1 along with
the relationship between the analog input levels and
the digital output. When the analog voltage at VIN+ is
less than the analog voltage at VIN-, the output of the
comparator is a digital low level. When the analog
voltage at VIN+ is greater than the analog voltage at
VIN-, the output of the comparator is a digital high level.
FIGURE 8-1:
SINGLE COMPARATOR
VIN+
+
VIN-
–
Output
VIN-
VIN+
Output
Note:
The black areas of the output of the
comparator represents the uncertainty
due to input offsets and response time.
© 2009 Microchip Technology Inc.
DS41291F-page 83