|
PIC16F1946 Datasheet, PDF (390/440 Pages) Microchip Technology – 64-Pin Flash-Based, 8-Bit CMOS Microcontrollers with LCD Driver and nanoWatt XLP Technology | |||
|
◁ |
PIC16F/LF1946/47
29.2 DC Characteristics: PIC16F/LF1946/47-I/E (Industrial, Extended) (Continued)
PIC16LF1946/47
PIC16F1946/47
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C ï£ TA ï£ +85°C for industrial
-40°C ï£ TA ï£ +125°C for extended
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C ï£ TA ï£ +85°C for industrial
-40°C ï£ TA ï£ +125°C for extended
Param
No.
Device
Characteristics
Min. Typâ Max. Units
VDD
Conditions
Note
Supply Current (IDD)(1, 2)
D017
â
130
175
ïA
â
190
250
ïA
D017
â
150
250
ïA
â
210
345
ïA
â
270
425
ïA
D018
â
610 1000
ïA
â
990 1500
ïA
1.8 FOSC = 500 kHz
3.0 MFINTOSC mode
1.8 FOSC = 500 kHz
3.0 MFINTOSC mode (Note 5)
5.0
1.8 FOSC = 8 MHz
3.0 HFINTOSC mode
D018
â 0.650 1.1
mA
1.8 FOSC = 8 MHz
â
1.1
1.6
mA
3.0 HFINTOSC mode (Note 5)
â
2.0
2.8
mA
5.0
D019
D019
D020
D020
D021
â
1.0
1.5
mA
â
1.5
2.5
mA
â
1.1
1.6
mA
â
1.6
2.6
mA
â
3.1
4.6
mA
â
200
350
ïA
â
350
550
ïA
â
240
400
ïA
â
370
650
ïA
â
860 1350
ïA
â
2.6
4.5
mA
â
3.2
5.0
mA
1.8 FOSC = 16 MHz
3.0 HFINTOSC mode
1.8 FOSC = 16 MHz
3.0 HFINTOSC mode (Note 5)
5.0
1.8 FOSC = 4 MHz
3.0 EXTRC mode (Note 3, Note 5)
1.8 FOSC = 4 MHz
3.0 EXTRC mode (Note 3, Note 5)
5.0
3.0 FOSC = 32 MHz
3.6 HS Oscillator mode (Note 6)
D021
Note 1:
2:
3:
4:
5:
6:
â
2.6
4.5
mA
3.0 FOSC = 32 MHz
â
6.0
8.0
mA
5.0 HS Oscillator mode (Note 5, Note 6)
The test conditions for all IDD measurements in active operation mode are: OSC1 = external square wave, from
rail-to-rail; all I/O pins tri-stated, pulled to VDD; MCLR = VDD; WDT disabled.
The supply current is mainly a function of the operating voltage and frequency. Other factors, such as I/O pin loading
and switching rate, oscillator type, internal code execution pattern and temperature, also have an impact on the current
consumption.
For RC oscillator configurations, current through REXT is not included. The current through the resistor can be extended
by the formula IR = VDD/2REXT (mA) with REXT in kïï®
FVR and BOR are disabled.
0.1 ïF capacitor on VCAP (RF0).
8 MHz crystal oscillator with 4x PLL enabled.
DS41414A-page 388
Preliminary
ï£ 2010 Microchip Technology Inc.
|
▷ |