70592C Datasheet, PDF (171/314 Pages) Microchip Technology – High-Performance, 16-bit Microcontrollers

PIC24HJXXXGPX06A/X08A/X10A
REGISTER 17-2: I2CxSTAT: I2Cx STATUS REGISTER
R-0 HSC
R-0 HSC
U-0
U-0
U-0
ACKSTAT
TRSTAT
—
—
—
bit 15
R/C-0 HS
BCL
R-0 HSC
GCSTAT
R-0 HSC
ADD10
bit 8
R/C-0 HS
IWCOL
bit 7
R/C-0 HS
I2COV
R-0 HSC R/C-0 HSC R/C-0 HSC
D_A
P
S
R-0 HSC
R_W
R-0 HSC
RBF
R-0 HSC
TBF
bit 0
Legend:
R = Readable bit
-n = Value at POR
U = Unimplemented bit, read as ‘0’
W = Writable bit
HS = Set in hardware
‘1’ = Bit is set
‘0’ = Bit is cleared
C = Clear only bit
HSC = Hardware set/cleared
x = Bit is unknown
bit 15
bit 14
bit 13-11
bit 10
bit 9
bit 8
bit 7
bit 6
bit 5
bit 4
ACKSTAT: Acknowledge Status bit
(when operating as I²C master, applicable to master transmit operation)
1 = NACK received from slave
0 = ACK received from slave
Hardware set or clear at end of slave Acknowledge.
TRSTAT: Transmit Status bit (when operating as I²C master, applicable to master transmit operation)
1 = Master transmit is in progress (8 bits + ACK)
0 = Master transmit is not in progress
Hardware set at beginning of master transmission. Hardware clear at end of slave Acknowledge.
Unimplemented: Read as ‘0’
BCL: Master Bus Collision Detect bit
1 = A bus collision has been detected during a master operation
0 = No collision
Hardware set at detection of bus collision.
GCSTAT: General Call Status bit
1 = General call address was received
0 = General call address was not received
Hardware set when address matches general call address. Hardware clear at Stop detection.
ADD10: 10-Bit Address Status bit
1 = 10-bit address was matched
0 = 10-bit address was not matched
Hardware set at match of 2nd byte of matched 10-bit address. Hardware clear at Stop detection.
IWCOL: Write Collision Detect bit
1 = An attempt to write the I2CxTRN register failed because the I²C module is busy
0 = No collision
Hardware set at occurrence of write to I2CxTRN while busy (cleared by software).
I2COV: Receive Overflow Flag bit
1 = A byte was received while the I2CxRCV register is still holding the previous byte
0 = No overflow
Hardware set at attempt to transfer I2CxRSR to I2CxRCV (cleared by software).
D_A: Data/Address bit (when operating as I²C slave)
1 = Indicates that the last byte received was data
0 = Indicates that the last byte received was device address
Hardware clear at device address match. Hardware set by reception of slave byte.
P: Stop bit
1 = Indicates that a Stop bit has been detected last
0 = Stop bit was not detected last
Hardware set or clear when Start, Repeated Start or Stop detected.
© 2011 Microchip Technology Inc.
DS70592C-page 171