908E621_07 Datasheet, PDF (8/62 Pages) Freescale Semiconductor, Inc – Integrated Quad Half-Bridge and Triple High-Side with Embedded MCU and LIN for High End Mirror

STATIC ELECTRICAL CHARACTERISTICS
STATIC ELECTRICAL CHARACTERISTICS
Table 3. Static Electrical Characteristics
All characteristics are for the analog chip only. Refer to the 68HC908EY16 datasheet for characteristics of the microcontroller
chip. Characteristics noted under conditions 9.0 V ≤ V_SUP ≤ 16 V, -40°C ≤ T_J ≤ 125°C unless otherwise noted. Typical values
noted reflect the approximate parameter mean at T_A = 25°C under nominal conditions unless otherwise noted.
Characteristic
Symbol
Min
Typ
Max
Unit
SUPPLY VOLTAGE RANGE
Nominal Operating Voltage
Extended Operating Voltage (LIN only 8..18V)⁽⁹⁾
V_SUP1
9.0
—
16
V
V_SUP2
7.5
—
20
V
SUPPLY CURRENT RANGE
Normal Mode ⁽⁹⁾
V_SUP = 12 V, Analog Chip in Normal Mode (PSON=1), MCU Operating
Using Internal Oscillator at 32 MHz (8.0 MHz Bus Frequency), SPI,
I_RUN
—
25
—
mA
ESCI, ADC Enabled
Stop Mode ^{(9), (10)}
I_STOP
—
40
50
µA
V_SUP = 12 V, Voltage Regulator with limited current capability
Sleep Mode ^{(9), (10)}
I_SLEEP
—
12
20
µA
V_SUP = 12 V, Voltage Regulator off
DIGITAL INTERFACE RATINGS (ANALOG DIE)
Output terminals RST_A, IRQ_A, RXD (MISO probe only)
Low-state Output Voltage (I_OUT = -1.5 mA)
High-state Output Voltage (_IOUT = 250 uA)
V_OL
–
–
V_OH
3.85
–
V
0.4
–
Output terminal RXD - Capacitance ⁽¹¹⁾
C_OUT
–
4.0
–
pF
Input terminals RST_A, PWM (SS, MOSI, TXD probe only)
Input Logic Low Voltage
Input Logic High Voltage
Input terminals - Capacitance ⁽¹¹⁾
V
V_IL
–
–
1.5
V_IH
3.5
–
–
C_IN
–
4.0
–
pF
Terminals IRQ_A, RST_A - Pullup Resistor
Terminals SS - Pullup Resistor
Terminals MOSI, SPSCK, PWM - Pull-down Resistor
Terminal TXD - PULLup Current Source
R_PULLUP1
–
10
–
kOhm
R_PULLUP2
–
100
–
kOhm
R_PULLDOWN
–
100
–
kOhm
I_PULLUP
–
35
–
µA
Notes
8. Device is fully functional, but some of the parameters might be out of spec.
9. Total current measured at GND terminals.
10. Stop and Sleep mode current will increase if V_SUP exceeds 15 V.
11. This parameter is guaranteed by process monitoring but is not production tested.
908E621
8
Analog Integrated Circuit Device Data
Freescale Semiconductor