English
Language : 

PXD20 Datasheet, PDF (74/130 Pages) Freescale Semiconductor, Inc – PXD20 Microcontroller
◁
Electrical characteristics
Table 20. DC electrical characteristics (continued)
Symbol C
Parameter
Conditions1
Value2
Unit
Min Typ Max
IDDSTDBY2 CC D STANDBY2 mode
current8
D (64K SRAM on)
P
SXOSC (32 KHz9) ON and RTC
running
TA = –40oC — 470 — A
TA = 0oC
— 480 —
TA = 25oC — 481 490
D
TA = 55oC — 525 —
D
TA = 85oC — 650 —
P
TA = 105oC — 870 910
CC D
SXOSC (32 KHz) and RTC OFF
TA = –40oC
63 — A
D
TA = 0oC
85 —
P
TA = 25oC
93 100
D
TA = 55oC
95 —
D
TA = 85oC
190 —
P
TA = 105oC
390 430
IDDSTDBY1 CC D STANDBY1 mode
D
current
(8K SRAM on)10
P
SXOSC (32KHz) ON and RTC
running
TA = –40oC — 415 — A
TA = 0oC
— 422 —
TA = 25oC — 426 430
D
TA = 55oC — 575 —
D
TA = 85oC — 680 —
P
TA = 105oC — 810 915
CC D
SXOSC (32 KHz) and RTC OFF
TA = –40oC
20 — A
D
TA = 0oC
22 —
P
TA = 25oC
29 45
D
TA = 55oC
47 —
D
TA = 85oC
118 —
P
TA = 105oC
236 310
1 VDD = 3.0 V to 5.5 V, TA = –40 to 105 °C, unless otherwise specified.
2 IDDMAX is composed of the current consumption on all supplies (VDD12, VDDE_A, VDDE_B, VDDA, VDDR, VDDM, VDDPLL, and
VDD_DR). It does not include current consumption linked to I/Os toggling which is highly dependent on the application. The
given value is thought to be a worst case value with all peripherals running, and code fetched from code flash while modify
operation on-going on data flash. It is to be noticed that this value can be significantly reduced by application; switch-off not
used peripherals (default), reduce peripheral frequency through internal prescaler, fetch from RAM most used functions, use
low power mode when possible.
3 HIgher current may be sinked by device during power-up and standby exit. Please refer to inrush current in Table 21.
4 RUN current measured with typical application and accesses on both flash and RAM.
5 Data and Code Flash in Normal Power. Code fetched from RAM: DCUs running with 20MHz pixel clock, QuadSPI fetching data
at 80MHz, GPU accessing internal SRAM and external DRAM, DMA, RLE, and VIU active, Serial IPs CAN and LIN in loop
back mode, DSPI as Master, PLL as system Clock (4 x Multiplier) peripherals on (eMIOS/ADC/SMD/SSD/SGM) and running
at max frequency, periodic SW/WDG timer reset enabled.
PXD20 Microcontroller Data Sheet, Rev. 2
74
Preliminary—Subject to Change Without Notice
Freescale Semiconductor
 ▷