MC3610 Datasheet, PDF (9/67 Pages) List of Unclassifed Manufacturers – Axis Accelerometer

MC3610 3-Axis Accelerometer
Preliminary Datasheet
3.3 Pin Description
Pin
1
2
3
4
5
6
7
8
9
10
11
12
Table 2. Pin Description
Name
DOUT_A1
DIN_SDA ¹
VDDIO
VPP
INTN ²
NC
VDD
NC
GND
CSN
NC
SCK_SCL ¹
Function
SPI data output
I2C address bit 1
SPI data In
I2C serial data input/output
Power supply for interface
Connect to GND
Interrupt active LOW ³
No connect
Power supply for internal
No connect
Ground
SPI chip select
No connect
SPI Clock
I2C serial clock input
Notes:
1) This pin requires a pull-up resistor, typically 4.7kΩ to pin VDDIO. Refer to I2C
Specification for Fast-Mode devices. Higher resistance values can be used (typically
done to reduce current leakage) but such applications are outside the scope of this
datasheet.
2) This pin can be configured by software to operate either as an open-drain output or
push-pull output. If set to open-drain, then it requires a pull-up resistor, typically 4.7kΩ to
pin VDDIO.
3) INTN pin polarity is programmable in the (0x17) Interrupt Control Register.
mCube Proprietary.
APS-048-0042v1.6
© 2015 mCube Inc. All rights reserved.
9 / 67