CC2510FX Datasheet, PDF (182/253 Pages) List of Unclassifed Manufacturers – True System-on-Chip with Low Power RF Transceiver and 8051 MCU

CC2510Fx / CC2511Fx
0xDE15: USBCSOH – OUT EP{1-5} Control and Status High
Bit Field Name
Reset
R/W Description
7 AUTOCLEAR
6 ISO
5:4 -
3:1 -
0 OUT_DBL_BUF
0
R/W When this bit is set, the OUTPKT_RDY bit is
automatically cleared when a data packet of
maximum size (specified by USBMAXO) has been
unloaded into the OUT FIFO.
0
R/W Selects OUT endpoint type.
0 – Bulk/Interrupt
1 – Isochronous
00
R/W Unused. Must be 0.
000
R0 Unused
0
R/W Set this bit to enable double buffering of data
packets.
0xDE16: USBCNT0 – Number of received bytes in EP0 FIFO (USBINDEX = 0)
Bit Field Name
Reset
R/W Description
7:6 -
5:0 USBCNT0[5:0]
00
0x00
R0 Unused.
R
Number of received bytes into EP 0 FIFO. Only valid
when OUTPKT_RDY is set.
0xDE16: USBCNTL – Number of bytes in OUT FIFO Low
Bit Field Name
Reset
R/W Description
7:0 USBCNT[7:0]
0x00
R
Number of received bytes into OUT FIFO selected
by USBINDEX register. Only valid when
OUTPKT_RDY is set.
0xDE17: USBCNTH – Number of bytes in OUT FIFO High
Bit Field Name
Reset
R/W Description
7:3 -
2:0 USBCNT[10:8]
0x00
0x00
R0 Unused
R
Number of received bytes into OUT FIFO selected
by USBINDEX register. Only valid when
OUTPKT_RDY is set.
Bit Field Name
7:0 USBF0[7:0]
0xDE20: USBF0 – Endpoint 0 FIFO
Reset
R/W Description
0x00
R/W Endpoint 0 FIFO register. Reading this register
causes one byte to be extracted from the EP0 FIFO.
The value of the extracted value is returned. Writing
to this register inserts one byte with the value written
into the EP0 FIFO. Note: The FIFO memory for EP0
is used for both incoming and outgoing data packets.
CC2510Fx/CC2511Fx PRELIMINARY Data Sheet (Rev. 1.2) SWRS055A Page 182 of
252