CC2510FX Datasheet, PDF (11/253 Pages) List of Unclassifed Manufacturers – True System-on-Chip with Low Power RF Transceiver and 8051 MCU

CC2510Fx / CC2511Fx
7 Electrical Specifications
T_A=25°C, VDD=3.0V if nothing else stated. Measured on Chipcon’s CC2510Fx EM reference
design.
Parameter
Min Typ Max Unit Condition
Power On Reset Voltage
1.1
V
Monitors the unregulated supply
Current Consumption
MCU Active Mode, static
500
µA
Digital regulator on, High Speed RCOSC running.
No radio, crystals, or peripherals.
MCU Active Mode, dynamic
270
µA/MHz
Digital regulator on, High Speed RCOSC running.
No radio, crystals, or peripherals.
MCU Active Mode, highest
speed
7.5
7.0
CC2510Fx: MCU running at full speed (26 MHz), XOSC
running. No peripherals.
mA
CC2511Fx: MCU running at full speed (24 MHz), XOSC
running. No peripherals.
MCU Active and RX Mode,
20
CC2510Fx: MCU running at full speed (26 MHz), XOSC
running, radio in RX mode. No peripherals.
mA
-100 dBm input
18
CC2511Fx: MCU running at full speed (24 MHz), XOSC
running, radio in RX mode. No peripherals.
MCU Active and RX Mode,
18
CC2510Fx: MCU running at full speed (26 MHz), XOSC
running, radio in RX mode. No peripherals.
mA
-30 dBm input
16
CC2511Fx: MCU running at full speed (24 MHz), XOSC
running, radio in RX mode. No peripherals.
MCU Active and TX Mode,
0dBm
23
21
CC2510Fx: MCU running at full speed (26 MHz), XOSC
running, radio in TX mode. No peripherals.
mA
CC2511Fx: MCU running at full speed (24 MHz), XOSC
running, radio in TX mode. No peripherals.
Power mode 1
Digital regulator on, High Speed RCOSC and crystal
187
µA oscillator off. 32.768kHz XOSC, POR and ST active.
RAM retention.
Power mode 2
Digital regulator off, High Speed RCOSC and crystal
0.5
µA oscillator off. 32.768kHz XOSC, POR and ST active.
RAM retention.
Power mode 3
0.3
µA
No clocks. RAM retention. Power On Reset active.
Peripheral Current
Consumption
Add to the figures above if the peripheral unit is activated
Timer 1
10
µA/MHz When enabled
Timer 2
10
µA/MHz When enabled
Timer 3
10
µA/MHz When enabled
Timer 4
10
µA/MHz When enabled
Sleep Timer
0.5
µA
Including low-power RC oscillator or 32.768kHz XOSC
AES
50
µA/MHz When encrypting/decrypting
ADC
0.9
mA When converting
USART1 / USART2
12
µA/MHz
For each USART in use.
Not including current for driving I/O pins.
DMA
30
µA/MHz When operating, not including current for memory access
Flash write
3
mA
Table 5: Electrical Specifications
CC2510Fx/CC2511Fx PRELIMINARY Data Sheet (Rev. 1.2) SWRS055A Page 11 of 252