English
Language : 

E981.03 Datasheet, PDF (30/51 Pages) ELMOS Semiconductor AG – Autonomous MAC and individual physical address
KNX/ EIB TRANSCEIVER
PRODUCTION DATA - JAN 15, 2015
E981.03
E981.03
VST
V20
VCC
VIO
VBUSP,mean
VTemp
VBUS,current
INTERNAL
M
U
X
RAM
A
D
ACLK
0x397
ADC_VSTRES
0x398
ADC_V20RES
0x399
ADC_VCCRES
0x39A
ADC_VIORES
0x39D
ADC_VBUSP_MEAN
0x39E
ADC_TEMPRES
0x3B1
BUS_CURR_STAT
shift pattern
Figure 14. Digital Monitoring Functions
For measurement reasons the voltages are scaled to low
voltage domain V33I. The scaled voltages are converted
by the on chip ADC. For scaling factor look at chapter
Electrical Functions section Monitoring Functions. The
conversion results can be read by access to the result
registers. The VBUSP is an average value (tVBUSP(AV) = 5 ms).
ADC control cycle consists of two conversion cycles. The
bus voltage is converted in the first conversion cycle of
every control cycle. All other analog channels are con-
verted in the second slot of the control cycle. The result-
ing conversion rate is approximately
• 70 k samples for bus voltage
• 10 .. 20 k samples for all other sources
Note: From VST supervision an active SAVE_N signal is gener-
ated in case of falling supply voltages. This allows the host pro-
cessor to stop the application program and to save its data be-
fore the reset pin RESET_N becomes active.
ductor AG
1/1
PRELIMINARY INFORMATION Jan. 2012
Elmos Semiconductor AG reserves the right to change the detail specifications as may be required to permit improvements in the design of its products.
Elmos Semiconductor AG
Data Sheet
QM-No.: 25DS0046E.03
30/51